ASSEMBLY
Always remove battery pack before installing or removing blade.
When removing the blade from the tool, avoid contact with skin and use proper protective gloves when grasping the blade or accessory. Accessories may be hot after prolonged use.
ATTACHING / REMOVING BLADE
If the blade clamp screw will not loosen enough to allow blade installation, tap gently on the end of the wrench with a mallet until the clamp screw breaks free.
ATTACHING THE BLADE:
1.Remove the battery pack.
2.Retract the lower guard (see Fig. 1).
3.Slip the blade into place (see Fig. 2).
4.Put clamp washers and clamping screw loosely in position.
5.Use the wrench to tighten the clamping screw while pressing down on the clamping knob (see Fig. 3 and Fig. 4).
6.Remove wrench.
7.Replace the battery pack.
REMOVING THE BLADE:
1.Remove the battery pack.
2.Use the wrench to loosen the clamping screw while pressing down on the blade safety lock button (see Fig. 3 and Fig. 4).
3.Remove the blade.
4.Tighten the blade clamp screw back into place.
5.Remove wrench.
6.Replace the battery pack.
FIG. 2
FIG. 1
FIG. 3 | FIG. 4 |
LOOSEN: | TIGHTEN: |
CLOCKWISE |
ADJUSTING DEPTH AND ANGLE
ADJUST CUTTING DEPTH: 1. Remove the battery pack.
2. Hold the saw firmly and loosen the depth adjustment knob by turning it
3. Move the shoe to obtain the desired depth of cut.
4.Tighten depth adjustment knob securely by turning clockwise
DEPTH ADJUSTMENT before operating the saw.
KNOB
BEVEL ANGLE KNOB
ADJUST BEVEL ANGLE:
1. Remove the battery pack.
2. Loosen the bevel angle knob by turning it
3. Adjust the angle of your cut.
4. Tighten the angle knob securely by turning clockwise.
30º
15 | 16 |
