INSTALLING A
COOKING SHEET
1. Raise
2. Lay the 20'' x 24'' (508mm x 610mm) cooking sheet on the griddle plate with 20'' (508mm) dimension front to back.
3. Lower the
4. Fold both edges of the cooking sheet over the head. While gently pulling the right side of the sheet to remove any slack, firmly push the cooking sheet mounting clip onto the right side mounting rib on top of the head.
5. Repeat process on the left side.
6. Reverse the process to remove the cooking sheet.
TIPS ON PROPER
HANDLING AND USE
OF COOKING SHEETS
To ensure long life of your Keating cooking sheets please follow the tips below:
Cooking sheets should never: λ Be folded or creased.
λ Be touched with sharp objects.
λ Come in contact with griddle scrapers or abrasive pads. λ Be placed under other equipment or objects.
Cooking sheets should always:
λ Be wiped with a damp soft cotton cloth after each run to remove any product residue.
λ Be cleaned after the griddle is shut down for the day.
The time to change a Cooking Sheet is when: λ Product starts sticking to the sheet.
λ Too much carbon
λ The head surface is cool.
λ The sheet is torn or ripped.
WARNING
THE
4
LEVELING OF
COOKING HEAD(S)
The cooking head(s) were leveled at the factory.
∞ NOTE: For best results, level griddle before checking. Adjust legs or stand casters to level griddle.
REMOVAL OF
COOKING HEAD
∞ NOTE: To identify parts, refer to page 7.
1. Turn off griddle and disconnect
2. Remove the cooking sheet by lifting off cooking sheet mounting clips.
3. Place a layer of soft cloth and then a layer of cardboard onto griddle plate under cooking head to protect MIRACLEAN® surface.
4. Raise cooking head completely to release tension on cooking head support pin. Remove support pin and its cotter pin and carefully lower cooking head to protected griddle surface.
WARNING
The cooking head is not supported after the cooking head support pin has been removed. If dropped the weight of the cooking head when unsupported will cause damage to the griddle surface or injury to personnel.
5. Do not turn the support pin in either direction.
6. To reattach the cooking head to the ram lift arm, raise cooking head completely and replace cooking head support pin. Insert a new stainless steel cotter pin to secure support pin, holding support pin to keep it from spinning.
7. Replace cooking sheet. See - “Installing a Cooking Sheet”.