Kelvinator ER 1642 T manual Using the Appliance, Before Use, Φ To Start the Appliance

Using the Appliance

Before Use

Remove all securing tapes.

Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5 ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly.

Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or products containing alcohol.

ΦTo Start the Appliance

1.Allow the appliance to stand for 2 hrs after installation.

2.Plug in the appliance and switch on at the mains supply.

3.Turn the thermostat control to the required setting. A setting of 3 - 4 is usually suitable for normal operation (see thermostat control).

4.Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside.

Thermostat Control

The thermostat control situated inside the refrigerator regulates the temperature of the larder compartment. Thermostat control is marked from 1-5 the higher the number, the colder the setting.

Position	0	-	Off
Position	1	-	minimum coldness
Position	5	-	maximum coldness
Model			If the ambient	Position of
			temperature is	drip tray
			greater than
ER 1642 T			+25 °C	Open (pos. 1)

The temperature inside the refrigerator and the 2-star compartment can be regulated further by adjusting the tray located under the 2-star compartment.

To obtain a lower temperature in the 2-star compartment when frozen food is stored inside and when the ambient temperature is 25 °C or lower push the tray in Position 2. When frozen food is not stored in the 2-star compartment and when the ambient temperature is higher than 25 °C pull the tray out to Position 1.

If frozen food is stored in the 2-star compartment and the ambient temperature is above 25 °C, pull the tray out to position 1 and turn the thermostat control to a colder setting (higher number). When the ambient temperature falls below 25 °C turn the thermostat control back to a medium setting and push the tray into position 2.

6