Kenmore 110.6705, 110.6707, 110.6706 manual Changing the Preset Dryness Level Settings

Changing the Preset Dryness Level Settings

If all your loads on all Auto Dry cycles are consistently not as dry as you would like, you may change the preset Dryness Level settings to increase the dryness, This change will affect all of your Auto Dry cycles.

Your Dryness Level settings can be adjusted to adapt to different installations, environmental conditions or personal preference, There are 3 drying settings: 1 (factory preset dryness level),

2 (slightly dryer clothes, approximately 15% more drying time) and 3 (much dryer clothes, approximately 30% more drying time).

1.The Dryness Level settings cannot be changed while the dryer is running.

2.Press and hold the Dryness Level button for 5 seconds. The dryer will beep, and "CF" will be displayed for 1 second followed by the current drying setting.

3.To select a new drying setting, press the Dryness Level key again until the desired drying setting is shown.

NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash.

4.Press START to save the drying setting.

5.The drying setting you selected will become your new preset drying setting for all Auto Dry cycles.

The dryer rack was shipped in the dryer drum.

Use the dryer rack for items that you do not want to tumble dry, such as sweaters.

Use Timed Dry to select the desired time.

NOTE: Do not use Auto Dry Cycles with the dryer rack. To use the dryer rack:

Do not remove the lint screen.

1.Open dryer door.

2.Slide dryer rack over the bottom of the dryer door opening. rest the back wire on the dryer back ledge. Push clown on the frame front to secure over lint screen.

3.Place wet items on top of the rack. Allow space around items for air to circulate, The rack does not move, but the drum will rotate. Make sure items do not hang over the edges or between rack grille.

4.Close the door.

5.Select TIMED DRY and TIME ADJUST MORE TIME or LESS TIME. Refer to the following table.

6.Select the desired temperature setting to match the fabrics in your load by pressing TEMPERATURE. Items containing foam, rubber or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table.

7.Start the dryer.

NOTE: Check the lint screen and remove any lint accumulated from items dried on the rack.

Suggested		Items for Rack		Cycle	Suggested
Drying				Setting	Time*
					(Minutes)
Washable		wool items		Low	20
(block to shape and lay fiat
on rack)
Stuffed	toys		or pillows	Low	30
(cotton	or polyester
fiber filling)
Stuffed	toys			Air Dry	50
(foam rubber			filled)
Galoshes		(rubber)		Air Dry	20
Foam rubber			pillows	Air Dry	50
Tennis shoes				Air Dry	20

*Reset time as needed to complete drying.

NOTE: You must remove rack for normal tumbling. To remove the dryer rack, lift it straight up and out of the dryer.

23