Kenmore 116.22823, 116.22822 owner manual To Remove Belt, To Replace Belt

TO REMOVE BELT

\	1. Turn Power-
	Mate® upside
	down.
	2. Unscrew the
	two (2) Power-
	Mate ® cover
	screws.
3. Turn Power-
Mate® right side
up. Press handle
release pedal and
lower the swivel.
Uft rear latches up.

4. TO remove cover, grasp the sides and

pull out, then up.

TO REPLACE BELT

1.Install new belt over motor drive, then over brush sprocket.

Motor

Drive

NOTE:	See
PARTS	AND	End Cap
FEATURES
for the	belt
number.

2. Place agitator

assemblyback into Power-Mate® .

3.Reinstall agitator cover by lining up the front tabs and slots and rotat-

5.Depress tabs on rear of

agitator cover and rotate cover forward to release from the

Tabs

ing downward until the latches

snap into ===

place.

Agitator Cover

Power-Mate ®

Agitator

base andCover remove.

6. Lift agitator assembly out and remove worn belt.

End Cap

4. Line up front of cover and base. Rest cover on

front edge of base as shown.

5. Rotate cover	\
back, Press
cover firmly until
side and rear
tabs snap into
place. Turn
Power-Mate ®
upside down and
replace two (2)
cover screws.

18