Hard Disk Drive (HDD)

Before using

If you purchase CDR-HD1300; this model is not equipped with a hard disk drive (HDD). Please purchase a commercially available HDD for internal use and install it on this unit correctly, following the attached instruction.

It is necessary to format a new HDD after installation. Also refer the attached instruction for formatting.

If you purchase CDR-HD1300E; this model is equipped with an HDD.

Capacity of the HDD

Following table shows the total recordable time for different capacities of an HDD.

Capacity

Total recordable time

20 GB

Approx. 30 hours

40 GB

Approx. 60 hours

60 GB

Approx. 90 hours

80 GB

Approx. 120 hours

Handling of the HDD

The HDD formatted on your CDR-HD1300 cannot be used on other CDR-HD1300s for any reading or writing. If you wish to use the HDD that has been formatted on other CDR-HD1300 on yours, format it again on your CDR-HD1300. See page 85 for formatting.

Carefully handle an HDD before installation because it is a precision device. Also do not give vibration or shock to this unit after the HDD is installed. Incorrect operation can damage the HDD and/or the data written onto the HDD.

Yamaha and suppliers accept no liability for the loss and/or damage of data caused by vibration and/or shock.

CD player mode

This unit does not make any recordings if no HDD is installed. In this case, only reading of a CD, CD-R, and CD-RW disc is possible. Permit some time until this unit becomes ready after the power is turned if no HDD is installed.

ii

English

Page 5
Image 5
Yamaha CDR-HD1300E Hard Disk Drive HDD, Before using, Capacity of the HDD, Handling of the HDD, CD player mode