Yamaha CDR-HD1300E owner manual HDD Utility, T a l 3 0 h 4 0 m, E d, A i l

The display changes for the menu item selection.

The display changes for the menu item selection.

HDD UTILITY

■To check the HDD utility (HDD Info.)

You can check the HDD utility (capacity, usage, and available space) of this unit.

1. Press MENU while this unit is in the stop mode.

2. Select “HDD Utility” by rotating the MULTI JOG knob (pressing +/– on the remote control).

H D D U t i l i t y

L

dB –30 –10 –6 –2 0

R

3. Press the MULTI JOG knob (ENTER on the remote control) to display “HDD Info.”.

H D D I n f o .

L

dB –30 –10 –6 –2 0

R

4. Press the MULTI JOG knob (ENTER on the remote control) again to display the capacity of the HDD. Each time the MULTI JOG knob is rotated (+/– on the remote

control is pressed), the display changes as follows. Indications are made by time.

Capacity (total time)

T o t a l 3 0 h 4 0 m
	L
	dB –30	–10	–6	–2 0
	R
Usage (total used time)
U s e d	2 h			3 m
	L
	dB –30	–10	–6	–2 0
	R
Available space (recordable time)
A v a i l	2 8 h			9 m
	L
	dB –30	–10	–6	–2 0
	R

Note

•The times displayed are rough estimates.

■To format the HDD (HDD Format)

You can format the HDD in this unit.

Cautions

•After the HDD has been formatted, all data about the recorded tracks and settings will be erased from the HDD.

•After all data on the HDD have been initialized, the undo function cannot be applied to any editing operations before formatting.

1. Press MENU while this unit is in the stop mode.

2. Select “HDD Utility” by rotating the MULTI JOG knob (pressing +/– on the remote control).

3. Press the MULTI JOG knob (ENTER on the remote control).

The display changes for the HDD utility item selection.

4. Select “HDD Format” by rotating the MULTI JOG knob (pressing +/– on the remote control).

H D D F o r m a t

L

dB –30 –10 –6 –2 0

R

5. “Initialize ?” appears on the display when the MULTI JOG knob (ENTER on the remote control) is pressed.

I n i t i a l i z e ?

L

dB –30 –10 –6 –2 0

R

6. “Format Really” appears on the display to make a confirmation when w/d (w on the remote control) is pressed.

F o r m a t R e a l l y

L

dB –30 –10 –6 –2 0

R

If you wish to format the HDD, press INPUT. If not, press a.

7. “Format OK” appears in the display when INPUT is pressed. Then the display returns to the one when the power of this unit was turned on.

Caution

•The method explained above cannot be used to format an HDD newly installed. To format an HDD newly installed, see the attached instruction.

APPENDIX

E-85

English