Yamaha CDR-HD1300E owner manual R W, 3 1, C a d j u s t

4. Press COPY twice.

The following message appears on the display, and this unit enters in the copy standby mode. Copying has not been started yet at this stage.

H D D	“ C D - R W			REC
	L	–10 –6 –2	0	GROUP
	dB –30			CDR
	ALL SYNC ANLG R
0 0 3	1 “ 1	0 0 0		REC
	L	–10 –6 –2	0	GROUP
	dB –30			CDR
	ALL SYNC ANLG R

5. Select the group on the HDD to be copied.

Rotate the MULTI JOG knob (press +/– on the remote control) to select the group on the HDD to be copied.

When a disc is selected:

0 0 3 1 “ 1	0 0 0	REC
L	–10 –6 –2 0	GROUP
dB –30		CDR
ALL SYNC ANLG R

When an album is selected:

0 0 3	1 “ 1	0 0 0	REC
ALBM	L	–10 –6 –2 0	GROUP
	dB –30		CDR
	ALL SYNC ANLG R

When a bookmark is selected:

M r k	1 “ 1	0 0 0	REC
	L	–10 –6 –2 0	GROUP
MARK	dB –30		CDR
	ALL SYNC ANLG R

COPYING FROM THE HDD ONTO A CD-R OR CD-RW DISC

6. Start copying.

Press w/d (w on the remote control) to start copying.

0 0 3 1 “ 1	0 0 1	REC
L	–10 –6 –2 0	GROUP
dB –30		CDR
ALL SYNC ANLG R

Notes

•OPC may start on the loaded CD-R or CD-RW disc depending on its recording condition. It takes approximately 15 seconds to complete the adjustment.

O P C A d j u s t		REC
L	0	GROUP
dB –30 –10 –6 –2		CDR
ALL SYNC ANLG R

When the adjustment has been completed, and the message above turns off on the display, copying automatically starts.

•The progress of elapsed time for the track being copied may vary by the data processing inside this unit.

To cancel copying, press a.

Caution

•If copying is canceled by a being pressed, only the data that has been recorded on the CD-R or CD-RW disc before the cancellation remains on the disc. When “Digital Move” (see page 65) is selected, the original data on the HDD which has already been copied to a CD-R or CD-RW disc will be deleted.

When copying has been completed, the operation of the HDD and the CD automatically stops.

7. Press FINALIZE to start finalization.

See page 70 for finalization.

Text data

If the copied data contains text data that can be copied such as a disc title, the TOC indicator flashes when copying is completed. If you attempt to open the disc tray by pressing v (OPEN/ CLOSE on the remote control), “TEXT Save ?” appears on the display.

•In order to copy the text data, perform finalization procedure.

•In order to open the disc tray without copying the text data, press v (OPEN/CLOSE on the remote control) again. However once the disc tray is opened, text data cannot be copied.

COPYING AND RECORDING ONT O A CD-R

OR CD -R

W DISC

E-61

English