TROUBLESHOOTING

 

 

 

 

 

 

 

SYMPTOM

CAUSE

REMEDY

 

 

This unit does not operate

The internal microcomputer has been frozen.

Turn off the power of this unit and then turn on again after

 

 

properly.

 

about one minute.

 

 

There is rotation noise of

The temperature inside this unit rises.

The fan starts to rotate to cool off the temperature inside

 

 

the fan.

 

this unit.

 

 

A noise occurs at the

A very low frequency component among the

Improvement can be made by adding a short fade-in or

 

 

change of the tracks that

wow and flutter of the analog record is being

fade-out to the track.

 

 

has been recorded from the

output as a noise.

 

 

 

analog record and edited.

 

 

 

 

Remote control does not

The batteries of the remote control are too

Replace 2 batteries with new ones.

 

 

work.

weak.

 

 

 

 

Remote control is from too far.

Use the remote control within 6m and 60 degrees radius.

 

 

 

Remote control is being used at an incorrect

 

 

 

 

angle.

 

 

 

 

Direct sunlight or lighting (of an inverter type

Change the position so that the remote control sensor is not

 

 

 

of fluorescent lamp, etc.) is striking the

exposed to strong lighting.

 

 

 

remote control sensor.

 

 

 

TV does not correctly

Remote control is being used near TV set

Relocate this unit away from the TV or cover the TV’s

 

 

function when the remote

with a remote control sensor.

remote control sensor.

 

 

control is being used.

 

 

 

 

The picture on the TV is

The indoor antenna is used.

Use an outdoor antenna, or set this unit away from the TV

 

 

impaired.

 

set.

 

 

 

 

The HDD cannot be

The HDD is not installed properly.

Install the HDD properly following the attached instruc-

 

 

selected.

 

tion.

 

 

 

 

 

 

 

 

The HDD newly installed is not formatted on

Format it on CDR-HD1300 you plan to use with.

 

APPENDIX

 

CDR-HD1300 you plan to use that HDD

 

 

 

 

 

 

 

with.

 

 

 

“Drive Check” appears on

The HDD is not set to “slave” properly.

Set the HDD to “slave” properly following the instruction

 

 

the display.

 

on the HDD.

 

 

 

 

 

 

 

ABOUT PRODUCT INFORMATIONS

YAMAHA Audio and Video website contain the latest product information, etc. Refer to the website to check the latest information.

YAMAHA Audio and Video website:

http://www.yamaha.co.jp/english/product/av/

E-93

English

Page 99
Image 99
Yamaha CDR-HD1300E owner manual About Product Informations