Install Side Burner Control Panel to Side Burner Assembly
[] Attach Side Burner Control Panel (iv]) to Side Burner Assembly Bolts and 2 Washers. Do not use a Washer on the end Bolt.
No Washer
Phillips Head Bolt: M4x5/16"
(Black) Qty: 3
Part # SB0009
Washer: | M4 | |
Qty: | 2 |
|
Part | # | SB0016 |
using 3 Phillips Head
With Washer
Install Side Burner Assembly to Firebox Assembly,
[] Loosely screw 2 Phillips Head Bolts (M6x3/8") and 2 Washers into the upper left and right corner holes in the left side of the firebox as shown in Inset 1. Leave 1/4" of the bolts extending out of the firebox sides to attach the side burner brackets. Slide the Side Burner Front and Rear Brackets over the heads of those bolts and tighten.
[] Slide the side burner ignition wire through the hole on the Side Burner Control Panel. See Inset 2
[] Use 2 Phillips Head Bolts (M6x3/8") and 2 Washers to attach the lower holes in the Side Burner Front and Rear Bracket to the Firebox Assembly (t) as shown in Inset 3.
Inset 1
Phillips | Head Bolt: M6x3/8" | Inset 3 | |
Qty: | 4 |
|
|
Part | # | SB0004 |
|
Washer: | M6 | Inset 2 | |
Qty: | 4 |
| 0 |
Part | # | SB0005 | |
Inset 2
15
