Installing LP Gas Fuel Gauge Assembly
1.Unscrew the M18x1.5 and M8x1.25 nuts from the Pressure Cylinder.
2.Unscrew and remove the Fixing Ring from the Dial. See Fig. 10a.
3.Insert the end with Pressure Cylinder through the notched hole on right Side Shelf. See Fig. 10b. Turn the Dial until it matches the notched hole, and push it into the hole.
4.Screw the Fixing Ring back to the Dial from the Pressure Cylinder side. See Fig. 10c.
5.Insert the Pressure Cylinder into Pressure Cylinder Guide, and secure using the de- tached M18x1.5 nut. See Fig. 11.
6.Attach Tank Hook to the lower thread of
Pressure Cylinder, and secure firmly using the detached M8x1.25 nut. Once tank is
connected, the dial wilt indicate amount of gas in tank.
Your natural gas grill is designed to operate on natural gas only, at a pressure of 7" water column (W.C.) (1/4 psig or 1.75 kpa), regulated at the residential meter. Check with your gas utility company for local gas pressure and with your local municipality for building code requirements. If your residential gas line pressure has not been regu- lated to 7" W.C., contact your local gas utility company for professional assistance.
It is recommended that a ShutoffValve be installed at the gas supply source outdoors. Install at a point after the gas pipe exits the outside walt and before the
Pipe sealing compound or pipe thread tape resistant to the action of natural gas must be used on all male pipe threads when making the connection.
Disconnect your gas grill from fuel source when the gas supply is being tested at high pressures. This gas grill and its individual shutoff valve must be disconnected from the gas supply pipe system during any pressure testing of that system at pressure in excess of 1/2 psi (3.5kpa).
Turn off your gas grill when the gas supply is being tested at low pressures. The grill must be
isolated from the gas supply pipe system by closing its individual manual shutoff valve during
any pressure testing of the gas supply pipe system at pressures equal to or less than 1/2 psi (3.5kpa).
Figure lOa
PRESSURE
CYLINDER
FIXING RING
Figure lOb
DIAL
NOTCHED
HOLE
PRESSURE
CYLINDER
Figure 10c
DIAL | FIXING RING |
PRESSURE
CYLINDER
Figure 11
_PRESSURE
CYLINDER
PRESSURE
CYLINDER GUIDE
TANK GUIDE
14
