Cleaning the Shuttle Race
This area must be kept free of dust, lint and tangled thread.
Clean the shuttle race area every three months.
• Cleaning the shuttle area
_ Bobbin case
_2_Levers
_3_Shuttle race cover
,_4_Shuttle
,_5_Shuttle race
,_6_Center pin on the shuttle
1. Raise the needle bar to its highest point, then and
remove the bobbin case _i_,.
2. Push the shuttle race levers ,_2_aside. Lift out the shuttle
race cover_3_and take the shuttle _4_out.
3. Clean the shuttle race _5_with a lint brush.
4. Put a drop of oil on the center pin of the shuttle _ and
the shuttle race _5_.Do not over oil.
, Replacing shuttle assernbly
..:2_,Levers
_3_,Shuttle race cover
,4_,Shuttle ..... .....
\5_,Shuttle race
,%_Center pin on the shuttle ::::::::::::::::::::::::::::::::::
L7_,Shuttle driver
\89Pointed hook
,,"9_(Oil here) ......
...... 7"
1. Turn the handwhee:! Se the shuttle forms a
half moon on the:i:ft::iae of the ma: i
2. Hold the shuttle '.,_:_ i tinter pi_ _d position the
shuttle so it forms a:R i : i i_ht side. The
hook _8_will be on the ..........
3. Put the shuttle race cover _, back into place over the
shuttle assembly.
4. Snap the levers ,,_,_2b_,back into the original position.
f,;\
\\
J
7O