$ig sal " °
, ,un,,
Water Heating
The Water Heating fight glows to indicate the dish- washer is heating water to the proper dishwashing temperature if your household water is not hot enough NOTE: The electronic time display will pause whife this occurs°
o All cycles (except Quick Rinse) automatically heat water during the final rinse.
Water heating is automatic in the wash portions of the Pots Pane cycle,
Water heating is an option in the main wash of the Norma! Wash and Water Miser cycles,
#etaj £atasi l®ast
...................lU,
Use Delay Wash when you want a cycle to start later, Delay Wash can be set to start the dishwasher during times when
'1. Close the door firmly until you hear it latch..
2.Press the Delay Wash pad and one hour of delay will show on the display. Each time you press the Delay Wash pad, the delay time will increase in
settings,, The longest delay setting is 9 hours.,
Hours of delay
3. Press pads for desired cycle and options.
iUl,, ii,,,,ll
In addition to showing remaining delay or cycle time, the digital display will show a code indicating the dishwasher's condition:
°PF will appear in the display the first time the dishwasher is connected to the elec-
trical supply after inetallation_ This display also indicates there was a power failure. Press Cancel/Drain to
drain the dishwasher. If there is no water in the dishwasher, press Cancel/Drain a second time, Reselect a cycle to restart the dishwasher.
Sani Complete
The Sani Complete light glows at the end of the cycle indicating a high temperature, sanitary rinse was completed° NOTE: A flashing Sani Complete light indicates that a high temperature, sani- tary rinse was not completed, The Sani Complete light will flash at the end of
the cycle if the dishwasher door is opened, power fails, or water heating is not completed during the final rinse. You may need to turn your water heater temperature up so water is at least 120°F (49°C) as it enters the dishwasher.
4_ The display will show the number of hours remain- ing until washing begins. The display will show hours only: If the display shows 2, there is be- tween 1 hour and 1 hour 59 minutes remaining.,
&When the hours of delay you have set have elapsed, the dishwasher will start the cycle se- lected in Step 3oThe wash time wi!l count down the minutes remaining in the cycle to O.
If you wish to put more dishes in the dishwasher
while it is in the delay mode, be sure to latch the door after adding them The timer wil! not advance unless the door is latched. To cancel Delay Wash, press the CanceVDrain pad.
°CC will appear on the display when the dishes are washed and the cycle completed, Opening the door or pressing the Cancel/Drain pad wifl dear the display.
E2 witl appear in the display if the selector pads are stuck. Press CanceVDrain to release
the controls, or run your fingers across the pads to free them up. If E2 remains in the display, call for service.
10
