Keep the rinse agent dispenser filled with a liquid
rinse agent. A rinse agent greatly improves dish drying by helping water flow off them during the last rinse, A rinse agent also keeps water from forming droplets and drying as spots or streaks°
To check dispenser:
o Check center of fill indicator cap. Clear means it needs filling,
A small amount of rinse agent automatically releases into the rinse water during the final rinse of each cycle. For best drying results, check dispenser periodically to see if it needs filling.
o Or remove fill indicator cap. An "E" is visible at the bottom of the dispenser when empty,
To fill dispenser;
The rinse agent dispenser holds 6 ounces
(! 75 mL), Under normal conditions, this lasts about 3 months.
1.Open dishwasher door completely
2.Remove fill indicator cap1
3. | Add rinse agent° Fill to smallest opening in lower | X | _ | Do not fill past | |
|
|
| |||
| part of dispenser only Overfilling may cause rinse |
|
|
| |
| agent to leak out., This will not harm the dish- |
|
|
| |
| washer, but could cause oversudsing |
|
|
| |
4. | Clean | up any spilled rinse agent with a |
|
| _=....=.,__/,_=_ smailes;openlng |
| damp | cloth |
|
|
|
5. | Replace fill indicator cap° Keep it closed tightly, |
|
|
| |
NOTE; You do not have to wait until the dispenser |
|
|
| ||
is empty before refilling, but do not overfill it. Your |
|
| "° | ||
dishwasher is designed to use a liquid rinse agent. |
|
| |||
You do not need to use a solid or |
|
| |||
rinse agent
Hot water dissolves and activates the dishwashing detergent. Hot water also dissolves grease on dishes and helps dry glasses
NOTE: The time showing on the electronic display will pause while water is heating, For more infor- mation, see "Dishwasher seems to run too long" on page 26.
To check water temperature:
1oRun hot water at the faucet closest to your dish- washer° Let the water run for at least 1 minute.
2.Measure the water temperature with a candy or meat thermometer,, Put the thermom- eter in the running stream of water.
3.If the water temperature at the faucet is below 120°F (49°C), have a qualified person raise the water heater's thermostat setting.
t2
