i WARNINGI
Electrical Shock and Personal
Injury Hazard
Disconnect electrical supply
before servicing or cleaning
the unit. Failure to do so could
result in electrical shock or personal injury from vacuum cleaner suddenly starting.
TO REMOVE BELT
Lay cleaner flat and flip cleaner to expose nozzle base. To remove nozzle guard, slide lock A to unlock position, to the left. Then depress lock B to unlock nozzle guard°
Rotate/pivot the nozzle guard and pull off
Lift and remove
brushrolL Dispose of old belt.
TO REPLACE BELT OR BRUSHROLL
Place new belt in area
of brushroll without bristleso
shutoff pedal in
__Place brushroll "Carpet" position..
shaft. Ensure to loop
the belt around the
j__Slide belt ontomo to r belt lifter shaft.
With new belt in place, pull and slide brushroll into nozzle making sure that the brushroll
end caps are in the correct orientation (see diagram for end cap orientation). Rotate brushroll manually
to make sure belt is properly aligned.
Secure by aligning
the three (3) tabs in the base slots.
To reattach nozzle guard, rotate/pivot back into position°
To secure nozzle guard, push lock B down to lock position. Slide lock A into lock position, to the right.
A
13
