To Attach the Embroidery Hoop to the

Machine

Turn the attaching knob (T)so it isparallel with the hoop,
and set iton the carriage
Attach the hoop by fitting the pins (_) into the carriage
holes (_;_,andturn the attaching knob {_ clockwise to
secure the hoop.
(D Attaching knob
(2_Pins
(.ElCarriage holes
Caution:
•Always pi'ovide sufficient clearance for' the embroidery
carriage behind your machine before embroidery
sewing,.
. Do not try to move the carriage by hand or touch the
carriage while it is moving
- Make sure to return the carriage to the home position
before turning off the power switch (see page 57).

To Attach Embroidery Foot P

_) Embroidery foot P
[_ Loosen the thumbscrew and remove the foot holder to
the rear,.
Attach Embroidery foot P(_ to the presser- bar from
behind.
[] Tighten the thumbscrew securely with the screwdriver.

Thread Holder

To prevent the needle thread from becoming tangled, place
the thread end on the thread holder (_
Pass the needle thread through the hole on embroidery foot
P and draw it up to the thread holder..
Hang about 3/4" to 1-1/2 (2 to 4 cm) of thread from front to
back on the thread holder:.
(i_:_Thread holder
_',_Hole on embroidery foot P
f
•/
[] %
®
J

--,.

54