Kenmore 385. 17622 owner manual Section Prepare Machine for Sewing, Choose Needle and Thread

			SECTION 2.	PREPARE	THE	MACHINE FOR SEWING
Set Up the	Machine (Continued)			Choose	the	Needle and Thread
• Free-Arm Sewing: the Removable		• Accessory Storage Box	Change the PresserFoot	• To Changethe Needle
Extension	Table

!

J

Needle clamp screw

%

Flat side away

fror£1

To Remove the Extension Table (for free-arm sewing)

1.Grip the table with your index finger and thumb, as shown.

2.Pull gently to the left, The extension table will snap out.

To Attach the Extension Table (for flat-bed sewing)

1.Insert the tab and the pin into their catches.

2.With your thumb and index finger, gently snap in.

The lid of the accessory storage box lifts open toward you.

Sewing accessories are conveni- ently located in the box.

Use the correct presser foot for the stitch you wish to sew.

To change the various presser feet, raise the presser bar to its highest position by lifting the presser foot lever.

Loosen the presser foot thumb screw, choose the proper foot, insert from the bottom.

Tighten the screw using the large screw driver to make certain the foot is secure.

you

)

NOTE: Raise the needle bar to its highest

position by turning the hand wheel toward you.

1. Loosen the needle clamp screw by turning it toward you.

2.Remove the needle by pulling it down- ward.

3.Insert the new needle into the needle clamp with the flat side away from you.

4.Push the needle up as far as it will go.

5.Tighten the needle clamp screw firmly

with the large screwdriver from the accessory box.