CAUTION
•Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety reasons.
•Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and LP tank off.
•Do not leave grill unattended while preheating or burning off food residue on high. If grill has not been regularly cleaned, a grease fire can occur that may damage the product. Follow instructions on General Grill Cleaning and Cleaning The Burner Assembly to prevent grease fires.
Ignitor Lighting
Do not lean over grill while lighting. 1. Open lid. Turn on gas at LP tank.
2.Turn left knob to 
preheat to light.
3.Push ignitor button rapidly (up to 5 times) to light. Be sure burner lights and stays lit.
4.If burner does not light, turn knobs to OFF, wait 5 minutes, try again.
5.Once left burner is lit, turn right knob to 
preheat to light.
6.If ignitor does not work, wait 5 minutes, then follow match lighting instructions.
After Lighting: Turn knobs to HIGH position for 
preheat position. Knobs and handle will become uncomfortably hot if left in preheat position.
CAUTION
If burner does not light, turn knobs to OFF, wait 5 minutes, and try again. Always close valve during the 5 minute waiting period. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidentally ignite with risk of injury.
Match-Lighting
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2.Match holder is on the right rear leg. Attach match to match holder, light match. Place match into match lighting hole from outside of grill bottom (as shown).
3.Push in and turn right knob to 
preheat position. Be sure burner lights and stays lit.
4.Light left burner by pushing left knob in and turning to 
preheat position.
Match lighting hole
Hose Check
•Before each use, check to see if hoses are cut, worn or kinked. Replace damaged hoses before using grill. Use only valve/hose/regulator specified in the Parts List.
Normal | Kinked |
Hose | Hose |
Before Your First Cookout
•Light burners, check to make sure they are lit, close the lid and warm up grill on HIGH for 15 minutes. This curing of paint and parts will produce an odor only on first lighting.
Burner Flame Check
•Light burner, rotate knobs from HI to LO. You should see a smaller flame in LO position than seen on HI. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
HI
LO
20 • 463350505
