NOTE: Right hand (RH) and left hand (LH) are determined from the operator's position while seated on the tractor.
STEP 1: (Figure 2)
Place the base bracket on a flat surface. Identify the highest hole on each side of the bracket.
STEP 2: (Figure 2)
Attach the base bracket as shown to the first and second holes from the end of the flattened base leg tube. Make only finger tight.
STEP 3: (Figure 3)
Attach the other end of the base bracket to the fourth and fifth holes from the end of a round base leg tube. Make only finger tight.
STEP 4: (Figure 4)
Attach the long end of the right support bracket to the outside of the flattened base leg tube. The bolt head must be on the inside of the base leg tube. Make only finger
tight.
STEP 5: (Figure 5)
Attach the left support bracket to the outside of the left base leg tube. Make only finger tight.
5/16" NYLOCK NUT
THIS HOLE
IS HIGHER 
5/16" x 2"
CARRIAGE BOLT 
BASE LEG TUBE (FLATTENED END)
BASE BRACKET
FIGURE 2
5/16" x 2"
CARRIAGE BOLT
THIS HOLE
IS HIGHER
| BASE LEG TUBE | ||
| (ROUND END) | ||
5/16" NYLOCK NUT | FIGURE 3 | ||
| 1/4" x 1" |
| |
RIGHT | CARRIAGE |
| |
BOLT | 1/4" NYLOCK | ||
SUPPORT | |||
| |||
BRACKET |
| NUT | |
(long end) |
|
| |
BASE LEG TUBE (FLATTENED END)
FIGURE 4
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT
LEFT | BASE LEG TUBE |
SUPPORT | |
BRACKET | (ROUND END) |
FIGURE 5
6 | Call |
| DO NOT RETURN TO STORE |