ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH SINGLE MOWER DECK SUSPENSION BRACKET

STEP 6: (Figure 6)

Insert the ends of the base leg tubes into the upper base tube.

STEP 7: (Figure 7)

Raise the tractor seat and remove the seat springs and the four bolts from the rear fender using a 1/2" socket.

STEP 8:

If the seat springs were mounted to the rear holes go to step 9. If the seat springs were mounted to the front holes go to step 10.

STEP 9: (Figure 7)

Place the base leg tubes onto the rear fender. Attach the front support brackets to the front holes in the fender reusing the bolts that were removed. Attach the base bracket and the seat springs to the rear holes in the fender using the bolts and washers shown. Do not tighten completely.

STEP 10:

Place the base leg tubes onto the rear fender. Attach the seat springs and front support brackets to the front holes. Use original bolts to attach base bracket to rear holes. Do not tighten completely.

STEP 11: (Figures 2-5)

Tighten the nuts and bolts assembled in figures 2-5 that fasten the base leg tubes to the base bracket and the front support brackets.

STEP 12: (Figure 7)

Center the base leg tubes on the rear fender and then, using moderate force, tighten the bolts assembled in figure 7 that fasten the base bracket and the front support brackets to the fender. Overtightening the bolts may damage the threaded holes in the fender.

STEP 13:

Skip to CANOPY INSTALLATION on page 9

UPPER BASE TUBE

BASE TUBE LEGS FIGURE 6

ORIGINAL

5/16" x 1"

BOLT

HEX BOLT

 

5/16" WASHER

 

SPRING

FIGURE 7

Call 1-866-576-8388 for missing parts or assembly help

7

DO NOT RETURN TO STORE