CANOPY INSTALLATION

STEP 1: (Figure 12)

Assemble the upright tubes to the base assembly.

NOTE: If holes are difficult to align, loosen bolts attaching base tubes to mounting bracket(s). If hole alignment is still difficult, loosen bolts attaching mounting bracket to rear fender. Retighten all bolts when finished.

UPRIGHT

TUBES

5/16" x 2"

PLASTIC CARRIAGE BOLT KNOB

5/16" FLAT

WASHER

FIGURE 12

STEP 2: (Figure 13)

Assemble the top tubes to the upright tubes. Do not

tighten yet.

STEP 3: (Figure 13)

Fit the front U-tube onto the top tubes. Fasten the tubes together. Tighten all loose bolts and nuts.

STEP 4: (Figure 13)

Fit the three support rods into the holes in the top tubes, with the rods arching upward. Do not over-bend the rods when installing.

1/4" x 1-1/2"

HEX BOLT

U-TUBE

1/4" NYLOCK NUT

1/4" x 1-1/2"

HEX BOLT

SUPPORT ROD

TOP TUBES

1/4" NYLOCK NUT

STEP 5: (Figure 14)

Place the vinyl canopy on top of the tubing frame, fitting the front of the vinyl canopy around the front U-tube. Secure the nylon mesh to the upright tubes using the ties located on the corners of the mesh.

CAUTION: Make sure tractor seat raises and lowers freely after attaching Sun Shade. The tractor's operator presence safety switch will not operate if seat is stuck down.

FIGURE 13

FIGURE 14

Call 1-866-576-8388 for missing parts or assembly help

9

DO NOT RETURN TO STORE