ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(1)1/2" or 9/16" Socket Wrench
REMOVAL OF PARTS FROM CARTON
•Remove all parts and hardware packages from the carton. Lay out all parts and hardware and identify.
ASSEMBLING SNOW CAB
Your tractor fender style may differ from the one shown in the drawings. These instructions apply to all fender styles.
•Raise the tractor seat, unscrew the seat spring bolts and remove the springs from the rear fender. See figure 1.
BOLT
WASHER
SPRING
FIGURE 1
•Push the plastic plugs into the ends of the base assembly tubes. See figure 2.
PLASTIC PLUG
•Spread apart the slotted ends of the base assembly's front brackets just enough to fit them on the outside of the seat hinge bracket. Slide the slots over the bolt heads. See figure 3.
IMPORTANT: The ends of the front brackets must fit snugly against the outside of the seat hinge bracket to keep the base assembly secured.
•Align the assembly's bottom brackets over the holes where you removed the seat springs. Check to see if the base assembly's tubing rubs against the fender. If the tubing rubs, apply the adhesive pads to the fender, under the tubing. See figure 3.
SEAT HINGE BRACKET
FRONT BRACKET
(BASE ASSEMBLY)
ADHESIVE PAD 
FIGURE 3
•Reassemble the seat springs on top of the base assembly's bottom brackets using the bolts and washers that you removed. Tighten securely, but do not to overtighten. See figure 4.
BOLT
WASHER
SPRING
FIGURE 2 | FIGURE 4 |
|
4
