Kenmore 587.1441 manual Care and Cleaning, Care of Drain Air Gap, To Disconnect Service

Care and Cleaning

Burn Hazard Allow heating element to cool before cleaning the interior.

Failure to do so can result in burns.

Outside—Occasionally wash with a mild nonabrasive detergent and water. Rinse and dry.

Inside—The inside of the dishwasher is self- cleaning with normal use.

To clean Stainless Steel wipe with the grains.

Use a Dishwasher Safe Detergent to help with the stains or discolorations.

Never use products that contain Chlorine Bleach or Citric Acid

Important: The dishwasher motor is permanently lubricated at the factory and does not need to be oiled.

Care of Drain Air Gap

If a drain air gap was installed for your built-in dishwasher, check to make sure it is clean so the dishwasher will drain properly. Drain air gaps are usually mounted on countertop and can be inspected by removing the cover. A drain air gap is not part of your dishwasher and is not covered by this warranty.

Winterizing

A dishwasher left in an unheated place should be protected from freezing. Have a qualified person do the following:

4.	Disconnect drain line from pump and drain	ENGLISH
To Disconnect Service:
1.	Turn off electrical power to the dishwasher at
	the supply source by removing fuses or tripping
	circuit breaker.
2.	Shut off water supply.
3.	Place a pan under the inlet valve. Disconnect
	water line from inlet valve and drain into pan.

water into pan.

Note: See Installation Instructions for more details.

To Restore Service:

1.Reconnect the water, drain, and electrical power supply.

2.Turn on water and electrical power supply.

3.Fill both detergent cups and run dishwasher through a NORMAL WASH Cycle.

4.Check connections to make sure they do not leak.

Note: See Installation Instructions for more details.

11