BEPORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME

continued from page 4

 

12. Stearowillcontinuetopassthroughforafewmin-

water which may have some harmless carbon

utes. After unit cools, rinse out kettle,

tines (very fine black particles) in it fromthe filter.

13.Shake the carafe, then discard the first batch of

MAKING PURIFIED WATER

1.Set the Purifier on your countertop or table.

2.Unplug the kettle from the base (Figure 1). Twist the cover counter-clockwise to remove, and set aside.

3.Rinse and fill the ketfie with tap water up to the max. fill line.

NOTE: You can pudfy less than the full amount. Use this chart as a guide. DO NOT fill the kettle over the max. fill line because the carafe will overflow.

WHEN YOU FILLWlTH THE CYCLE TAKES

TAP WATER TO...

Model

344800

(3

qt.)

5

hours

Modet

3448"t0

(1

gallon)

4

hours

4.Replace the cover on the kettle. Twist cover clockwise to lock. Plug the kettle into the base unit. Carry carefully and keep level to prevent splashing.

5, Set the carafe into place on base unit,

6.Plug the power cord into any 120 volt outlet.

7.Press the reset or start button. The red indicator light will illuminate.

WhenthecyclaisoverthePurifiertumsoffautoroa_cal-

ly. AFTER THE FAN MOTOR GOES OFF, WAIT AT LEAST 30 MINUTES BEFORE REMOVING THE COVER...

WARNING: NEVER REMOVE THE COVER WHILE

THE FAN MOTOR IS RUNNING, OR FOR 30 MIN-

UTES AFTER IT STOPS. YOU COULD GET SE- VERE BURNS FROM THE BOILING WATER OR STEAM.

B.To pour water from carafe, open spout by pulling on center stdp in direction of the arrow indicator

near thumb position.

9.Store the carafe filled with product watar in the re- frigerator until you need it.

10.After the Purifier has ccoled (wait for 30 roinutes after the fan motor stops running) remove the kettle to clean.

CARE AND CLEANING OF YOUR WATER PURIFIER

KEI-rLE

CLEANING EXTERIOR SURFACES

After each use, dnse theinside with lukewarm tap water and remove any residue. Clean by wiping out the inside of the kettle with a damp cloth and rinse. If a deposit starts to form at the bottom, use Kenroore Water Pudfier cleaner (see page 7). ReSidue build up on the bottom of the kettle will prevent the system from purifying

a complete batch of water. Remove the kettle from base unit. Fill kettle at the sink wfth hot water and follow the instructions on the cleaner boffie. Rub with a soft

scouring pad and rinse thoroughly.

CAUTION: DO NOT IMMERSE THE PURIFIER OR KETTLE IN WATER.

CARAFE

Clean with mild dish detergent and soft cloth. Rinse thoroughly with water.

TO keep your Purifier looking new, you should paded- icafly clean the exterior plastic surfaces with a soft, damp cloth. DO NOT use any caustic cleaning solu- tions, scoudng pads or powder because they will damage the plastic finish.

THERE

ARE NO USER SERVICEABLE

PARTS

INSIDE

THE UNIT. NOTICE

J

CHANGING THE CARBON RLTER

IMPORTANT: The purifier uses a carbon filter in the ca- rafe cover to remove traces of odors before the purified water is collected in the carafe. The filters last about 2-3 months. A retum of unwanted odor means the tilter should be replaced. Order replacement carbon filters from Sears (see page 7).

continued, page 6.

5

Page 5
Image 5
Kenmore 625.344800 Making Purified Water, Care and Cleaning of Your Water Purifier, Cleaning Exterior Surfaces, Carafe