INSTALLATION STEPS (cont.)
REFER TO PAGE 5. If optional kits are used, follow
instructions included with them.
1. Close the cold water side shutoff valve. (Usually, there already is a shutoff under the sink. If not, close the main water shutoff valve near the water meter or
pressure tank.)
2.Cut and remove a section of the cold water pipe.
3.If plumbing with flexible tubing, hang or support
the filter housing in some manner. If using rigid
pipe, be sure to allow a minimum of
under the filter for sump removal when changing the filter cartridge.
4.Use the plumbing procedures on page 5 if using
compression fittings. Follow procedures on pages 5
and 6 for sweat copper and threaded pipe installa- tion. Be sure water flow is into the filter inlet side
and from the outlet side to the faucet.
Note: A grounding jumper wire is not required.
5. Before turning on the water supply remove the sump from the filter head and install the filter car- tridge (see below).
FILTER CARTRIDGE INSTALLATION
TURN TO PAGE 9 AND FOLLOW ALL STEPS UNDER "FILTER CARTRIDGE REPLACEMENT".
