Step 3 - Connect Tubes
CONNECT YELLOW TUBE TO WATER SUPPLY FITTING
1.Locate the yellow tube. One end is attached to the fil- ter housing. Run the other end to the water supply fit- ting on the cold water pipe. See Figure 8.
2.Refer to the “Cut Tubes to Length” section, below, and cut the yellow tube square and to length as needed.
3.Refer to the “Connect Tubes” section, below, and insert the yellow tube all the way into the 3/8” quick connect fitting on included water supply fitting (installed in Step 1).
4.Pull on the tube to be sure it is held firmly in the fit- ting.
HOW TO CUT AND CONNECT THE TUBES
Your Advanced
Cut tubes to length
1.Use a sharp cutter or knife to cut the end of tubing. Always cut the tubing square. See Figure 9.
2.Inspect the end (about 1") of the tubing to be sure there are no nicks, scratches or other rough spots. If needed, cut the tubing again.
Connect tubes
1.Push tubing through collet, until it engages the
2.If using tubing other than tubing supplied with the system, be sure it is of high quality, exact size and roundness with a smooth surface.
Disconnect Tubes
1.Push the collet inward with a finger tip. See Figure 12.
2.Continue holding collet inward while pulling the tub- ing out. See Figure 13.
SINK
cold water
supply fitting
yellow tubing
cold water | filter |
shutoff | housing |
Push In Fitting
Tube
Cut tubing square with end of tubing round, smooth, with no cuts, nicks or flat spots.
Tube Correctly Cut
ColletO-Ring
Tube Partially Engaged With Fitting
ColletO-Ring
Tube Fully Engaged With Fitting
Collet (Depress to
Remove Tubing)
Figure 8
Figure 9
Figure 10
Figure 11
Collet
Fitting
Tubing
Collet and | Figure 13 |
Disconnect Tubing
Figure 12
Questions? Call The Kenmore Water Line
8