_,;;_;;_;SECTION 5 _'_'__.1
SERVICE TECH. INFORMATION
A. TROUBLESHOOTING
CORRECT SWITCH DISPLAYS
_ p
VALVE CYCLE STATUS
Valve in service, fill, brining, backwash or fast rinse position
Valve rotating from one position to another
TIMER PWA REPLACEMENT: Be sure the
valve is in service position when replacing the timer PWA (observe valve cycle indicator).
If, after installing and programming the re-
placement timer PWA, the valve is not in ser-
vice position, do the following to assure correct
cycle orientation, or timing, between the face- plate and valve.
C. While in this diagnostic screen, the following in-
formation is available and may be beneficial for
various reasons. This information is retained by
the computer from the first time electrical power
is apphed to the face plate.
-- Press [] to display the number of days this face plate has had electrical power apphed.
--Press [] to display the number of regenera-
tions initiated by this face plate since the SR code number was entered.
Use the MANUAL ADVANCE procedures,
page
advance through the recharge cycles until the
valve stops in service position, and RE- CHARGE no longer flashes in the display.
NOTE: The valve motor may automatically
drive through several valve positions while
searching for service. If an error code occurs,
unplug the transformer, then plug in again.
d3_
_ Press and hold the SELECT button until...
SR 22 shows. | CODE |
UltraSoft 1O0 | 5R22 |
/tONI
position markers (valve in service)
SR 24 shows.
UltraSoft 150
This code identifies the softener
size. If the wrong number shows,
operate on incorrect programming. ing as needed.
cCO£
5R2H
nominal capacity the softener will
Do the follow-
CAMMOTOR
Return the present time display -- Press the SE-
LECT button.
To change SR number
the SELECT button and reset the timer...page
Problems, | Questions? | Call 1- 800- 426- 9345 Kenmore | Water | Line |