Kenmore 625.38816 Program Thetimer, SET Water Hardness Number, SET Recharge Regeneration Time

C. PROGRAM THETIMER

B SET WATER HARDNESS NUMBER

•Press the SELECT button once to display 25 (flashing) and HARDNESS.

The grains per gallon (gpg) hard-

ness of your water supply is on

your water analysis report. Be sure to enter water test results on

page A, for future reference.

If your water supply contains iron, compensate for

it by adding to the water hardness number. For ex- ample, assume your water is 20 gpg hard and contains 2 ppm iron. Add 5 to the hardness number for each I ppm of iron. In this example, you would use 30 for your hard- ness number.

	20	gpg hardness
2 ppmironx5	= 10 +10
(times)	30	HARDNESS NUMBER

•Press the UP / DOWN buttons to set your water

hardness number in the display. The DOWN button

moves the display to 1. The UP button moves the

display to the highest setting (see maximum setting for your model in the specifications).

Note:

Each press of the UP / DOWN button changes the

display by I between I and 25. Between 25 and the

highest number, the display changes 5 at a time... 25, 30, 35, etc. Holding the UP or DOWN but- ton in changes the display twice each second.

_SET RECHARGE (REGENERATION) TIME

• Press the SELECT button to display 2:00 A_M

(flashing)	and RECHARGE	TIME.	7,1717 A_
At the 2:00 AM recharge time			C'uu /
setting, the softener begins re-
generation	(see pages 2-3	and

2-4) at 2:00 AM, ending no later

than 4:00 AM. This is a good time in most house- holds because water is not being used (see Auto- matic Bypass, page 2- 4). If a different recharge time

setting would be better for your household, do the following.

•Press the UP / DOWN buttons to set the desired

recharge starting hour. Be sure to observe the AM- PM as you did when setting the present time of day.

Note:

Each press of the UP / DOWN buttons changes the

display I hour. Holding the buttons in changes the display twice each second.

_SET SALT EFFICIENCY

A new feature in this modelis Salt Efficiency. When this feature is ON, the unit will operate at salt effi-

ciencies of 4000 grains of hardness per pound of salt or higher which will reduce the softeners salt usage.

•Press and hold for 3 seconds the SELECT button

until the following screen is displayed.

.,o

I

WATER METER (A) SWlTGH (B)

More information on this particular display is

found in the Troubleshooting Section of the manual,

under Manual Initiated Electronics Diagnostics.

•Once in this display, press the SELECT button and

one of the following two displays is shown.

_I

•Press the UP button to set this feature ON, press the DOWN button to set OFF. When the Salt Effi-

ciency is ON, the icon will be displayed in the nor- mal run display.

•Press the SELECT button once again, to com-

plete initial programming, and RECHARGE TO- NIGHT shows in the display.

IF YOU NEED HELP PROGRAMMING THE TIMER, CALL TOLL FREE,

NUMBER 1- 800-426- 9345.

SEE PAGE 2-1FOR OTHER FACE PLATE TIMER FEATURES.

1-4

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line