Installing
1.Measure the height of your kitchen cabinet opening. The top of the compactor should be a minimum of ¹ " (3 mm) from the top of the kitchen cabinet opening.
The rear wheels are preset for a kitchen cabinet opening height of 34¹⁄₄" (87 cm) (position 1).
To adjust for other kitchen cabinet opening heights:
■Loosen
■Move the rear wheel and stud to position 2 or 3 as needed for your kitchen cabinet opening measurement:
Position 2: 34¹⁄₄" to 34⁷⁄₁₆" (87 to 87.5 cm)
Position 3: 34⁷⁄₁₆" to 34⁵⁄₈" (87.5 to 88 cm)
NOTE: To level the unit in position 3, you may need to add shims under the front leveling legs.
■Tighten screw. Repeat for other rear wheel.
B
1C
2
3
A
D
A. Wheel bracket assembly
B. Compactor cabinet
C. Locating stud
D.
2.Use pliers to lower front leveling legs away from compactor cabinet. Adjust legs so there will be a ¹⁄₈" (3 mm) to ¹₄ "
(6.4 mm) space between the top of the compactor and the top of the kitchen cabinet opening. Stand the compactor upright.
3.Move the compactor close to its final position.
4.To install handle:
■Insert screws into the holes from the inside of the drawer.
■Place handle on the front of the drawer and align handle screw holes with screw ends. (The handle should appear as a “smile” when installed.)
■Tighten screws snugly.
A
B
C
A. 2 screws inserted into holes from inside of drawer
B. Top of drawer
C. Handle installed on drawer front
5.Plug into a grounded 3 prong outlet.
6.Determine whether you want the compactor cabinet or drawer front flush with the kitchen cabinet face.
Using 2 - #8 - 18 x ⁵₁₆ " mounting screws (provided), attach the retaining brackets to the compactor cabinet top as needed.
■If the compactor cabinet face is to be flush with the kitchen cabinet face, place retaining bracket mounting screws through “1.”
■If the compactor drawer front is to be flush with the kitchen cabinet face, place retaining bracket mounting screws through “3.”
■If the compactor is to be midway between “1” and “3,” place the retaining bracket mounting screws through “2.”
A
B
3 2 1
A.Countertop
B.Retaining bracket
7.Slowly lift the front slightly and roll compactor into the kitchen cabinet opening.
8.Using 2 - #8 - 18 x ¹₂ " mounting screws (provided), fasten the retaining brackets to the countertop with the mounting screws.
Countertop mounting
A
B
C
A.Countertop
B.Retaining bracket
C.Mounting screw (provided)
NOTE: If retaining brackets cannot be attached to the underside of countertop, attach mounting clips (provided) to retaining brackets. Fasten compactor to kitchen cabinet face with mounting screws through the mounting clips.
7