Kenmore 665.16739 Changing a Cycle or Setting, Adding Items During a Cycle, Option Selections

		Use this rinse cycle for				Do not use
		rinsing dishes,		glasses,		detergent
		and silverware that will				with	this
		not be washed		right away.		cycle,
Soil	Wash	Rinse	Main	Rinse	Final	Dry	Time	Water
Level			Wash		Heated		(rain)	Usage
Sensed					Rinse			(gal/L)
		•		•			14	4.3/16,4
Heavy
				•			10	2.2/8.2
Ught

NOTE: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary from the numbers above as the sensor adjusts the cycle for the best wash performance.

Canceling a Cycle

Anytime during a cycle, press

O

CANCEL/DRAIN glows. The dishwasher pauses for about 5 seconds and starts a 2 minute drain (if needed). Let the

dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press CANCEL/DRAIN again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press CANCEL!DRAIN before starting the dishwasher to clear all options and cycles.

Changing a Cycle or Setting

During the first minute of a cycle

Press a new cycle and/or options.

After the first minute of a cycle

1.Press

CANCEL/DRAIN glows. The dishwasher pauses for 5 seconds and starts a 2 minute drain (if needed). Let the

dishwasher drain completely.

2.Check the detergent dispensers. If the main wash cup has opened and the detergent washed away, refill the cups as needed.

3.Close the door.

4.Press a new cycle and/or options.

5.Press START

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open the door end check the detergent dispenser. If the main wash section is still closed, you can add items.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2, Open the door. If the main wash detergent dispenser is still closed, add the item.

3, Close the door, but do not latch it. Wait 30 eeconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle after about a 5 second pause.

Option Selections

You can customize your cycles by pressing an option. If you change your mind, press the option again to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option

Press START to use the same cycle and option(s) as the previous
wash cycle,
any time before drying begins.
NOTE; If the last cycle you completed was a rinse cycle, when
you press	Start, the dishwasher runs the last full wash cycle and	m
options.
Hi Temp	Scrub

Select this option to heat the water during parts of the cycle. Hi Temp Scrub heats the water to 145°F (63°C) in the main wash. Heating the water helps improve washing results.

This option adds heat, water and wash time to the cycle.

NOTE: Hi Temp Scrub is an option with Pots Pans and Normal

Wash.

Sani Rinse

Select this option to raise the water temperature in the final rinse to approximately 155°F (68°C) for 10 minutes. Sani Rinse adds heat and time to the cycle. In the Normal cycle this high- temperature rinse sanitizes your dishes and g[aasware in accordance with the NSF Protocol P153 Sanitization and CJeaning Performance of Household Spray-Type Dishwashers,

NOTE; Sani Rinse is an option with Pats Pans, Normal Wash and Water Miser.

13