ULTRA WASH Soil Removal System
The ULTRA WASH soil removal system gives you sparkling clean dishes, while using less energy and time. The ULTRA WASH soil removal system includes:
•A
•An ULTRA WASH sensor to monitor soil level and adjust the cycles as needed.
•An Automatic Temperature Control (ATC) that ensures the proper water temperature for the selected wash cycle, and soil level of the load.
How the ULTRA WASH •oil removal system works
1.Load the dishwasher. Remove bones, large chunks or
2.Hot water fills the dishwasher to a level near the bottom of the overfill protection float.
3.The HEATING indicator glows, and the dishwasher pauses while the water is heated.
4.When the water reaches the proper temperature, the HEATING indicator turns off and the cycle resumes.
5.Detergent from the detergent dispenser is dispensed at the correct cycle times and hot water is pumped through the ULTRA WASH pump.
6.Hot water and detergent sprays against the soiled surfaces of the load and removes food particles.
7.Food soil is held in an accumulating chamber.
8.Food soil is disposed down the drain with the wash water.
START-UP GUIDE
Before using your dishwasher, remove all packaging materials. Read this entire Use and Care Guide. You will find important safety information and useful operating tips.
Using Your New Dishwasher
1.Scrape large food soil and hard items (toothpicks or bones) from dishes.
2.Properly load the dishwasher. (See "Dishwasher Loading.") Make sure nothing prevents the spray arm(s) from spinning freely.
3.Add detergent and check the rinse aid dispenser. Add rinse aid if needed. (See "Dishwasher Use.")
4, Push door firmly closed. The door latches automatically. Run hot water at the sink nearest your dishwasher until the water is hot. (See "Dishwasher Efficiency Tips,") Turn off water.
5. Press the desired cycle and option selections, (See "Dishwasher Use.") Press START. Or press START to repeat
the same cycle and options as the previous cycle.
9, Fresh, hot water enters the dishwasher and sprays on the dishes. The rinse water is then pumped through the ULTRA WASH soil removal system and remaining soil
is removed.
10.The food soil that is held in the ULTRA WASH soil removal system is disposed down the drain with the rinse water.
11.The final rinse water is heated. The rinse aid is added to the water for the final rinse to prepare the dishes for drying.
How the ULTRA WASH Sensor and the Automatic
Temperature Control (ATC) work
1.The ULTRAWASH Sensormeasuresthe amountof soil in the dishwasher.
2.After the soil level is determined, unnecessary portions of the cycle are skipped.
3.The ATC adjusts the water temperature throughout the cycle depending upon the soU level detected. Higher water temperatures are used to improve cleaning with heavier soiled loads.
7
