Questions and Answers
Operation
Question
Why is the oven light not on during cooking?
Why does steam come out of the air exhaust vent?
Will the microwave oven be damaged if it operates empty?
Does microwave energy pass through the viewing screen in the door?
Why does a tone sound when a pad on the control panel is touched?
Can my microwave oven be damaged if food is cooked for too long?
ARSWel _
There may be several reasons why the oven light is not on. Have you:
•Set a cooking time? Touched START?
° Checked the light bulb?
Steam is normally produced during cooking. The microwave oven has been designed to vent this steam.
Yes. Never operate the oven empty or without the glass turntable,
No, The metai screen bounces the energy back to the oven cavity. The holes (or ports) allow only light to pass through. They do not let microwave energy pass through,
The tone tells you that the setting has been entered.
Like any other cooking appliance, it is possible to overcook food to the point that the food creates smoke and even possibly fire, and damage to the inside of the oven. it is always best to be near the oven while you are cooking.
When the oven is plugged into walt outtet for the first time, it might not work properly. What is wrong?
The microcomputer controlling your oven may temporarily
become scrambled and fail to function as programmed when you plug in for the first time or when power resumes after a power interruption. Unplug the oven from the 120 volt household outlet and then plug it back in to reset the microcomputer.
Why do I see light reflection | around the | This light is from the oven light which is located | between the | ||
outer case? |
| oven cavity and the outer wall of the oven, |
| ||
What are the various sounds | I hear when | The clicking | sound is caused | by a mechanical | switch turning the |
the microwave oven is operating? | microwave | oven's magnetron | ON and OFE |
| |
The heavy hum and clunk is from the change in power the magnetron draws as it is turned ON and OFF by a mechanical switch,The change in blower speed is from the change in line voltage caused by the magnetron being turned QN and OFF.
18
