General Care & Cleaning (cont'd)
Special Door Care Instructions- Most oven doors contain glass that can break. Read the following recommendations:
1.Do not close the oven door until all the oven racks are fully in place.
2.Do not hit the glass with pots, pans, or any other object.
3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.
Oven Light
Wire
Holder
Changing the Oven Light (some models)
For models equipped with the interior oven light, the light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder (See Fig. 1). The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1.Turn electrical power off at the main source or unplug the range.
2.Press wire holder to one side to release the glass shield.
3.Replace bulb with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder into place.
5.Turn power back on again at the main source (or plug the range back in).
6.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide.
.... _ | _ | Be sure the range isunplugged and all parts are COOL before replacing |
Fig. 1 | oven light. Wear a | |
Adjusting the Oven Temperature
Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1.Press B.k°.
2.Set the temperature to 550°F (287°C) by pressing and holding the I%..
3.Within 2 seconds, press and hold ___Bakeuntil the 2 digit display appears. Release _. The display now indicates the amount
of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."
4.Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°C)_in5°Fstepsbypressingandh_ldingtheA or V. Adjust
until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign
5.When you have made the desired adjustment, press _ to go back to the time of day display.
Note: Oven temperature adjustments made will not change the
15
