Setting Surface Burner Controls
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of flame that you can control for two different heat levels, one for small and one for large cookware.
Large Caokware Operation (Figure 1; Zone A & B)
1.Place a large cooking utensil centered over the dual surface Burner Grate.
2.Push the surface control knob down and turn counterclockwise out of the OFF position.
3.Release the knob and rotate to the LITE position (Figures 2 & 3). Note: All electronic surface ignitors will spark at the same time. However, only the selected surface Burner will lite.
4.Visually check that the burner has llt.
5.When the burner is lit, continue to turn the control knob counterclockwise between the HI position and the MED position to adjust to the desired flame size for both burners together (figure 1). DO NOT cook with any of the surface control knobs in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).
Simmering Operation (Figure 1; Zone A)
1.Place a small cooking utensil centered over the dual surface Burner Grate.
2.Push the surface control knob in and turn counterclockwise out of the OFF position (See Figures 2 & 3).
3.Release the knob and rotate to the LITF position. Note: All electronic surface ignitors will spark at the same time. However, only the Dual Burner will ignite.
4.Visually check that zone A & B of dual burner has llt.
5.Continue to turn the gas control knob counterclockwise past the MED position; zone B will turn off. Adjust the simmer flame size by turning the control knob between the MED position to the LO position. DO NOT cook with the surface control knob in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).
LITE
Figure 3
Figure
Figure 2
Figure 4
11
