Kenmore 790.7156 manual Setting Oven Controls, Igi, Temperature conversion, To Set the Clock

Oven Control Functions

READ TH E iNSTRUCTiONS CAREFU LLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad functions of the oven as described below.

BROIL	PAD Used to	UP and	DOWN ARROW		PADS	Used along
select	the variable broil	with the	function	pads to	select	oven
function.		temperature, time		of day,	clean	time and

FEATUREINDICATOR

LIGHTS-- These light to show which feature is in

PAD Used

CLOCK SET to set the

time of da,.

TIMER ON/OFF

PAD--Used lo se_

or cancel me minute timer. The minute 1:liner does not slarl

or SlOP COOKing. Also

TIMER ON/OFF oaa s used to sel tile Continuous Bake feature.

/

SELECT SELF-CLEAN

PAD-- Used to select the

Self-Cleaning cycle. A 2, 3 or 4 hour Self-Clean

time may be selected.

minutetimer,

® ®

0

®

Q

P

OVEN, PREHEAT & DOOR LOCKED LIGHTS* -- The "OVEN" light will glow each time the oven turns on to maintain the set oven temperature. The "PREHEAT" light will glow when the oven is first set to operate, or if the desired temperature is reset higher than the actual oven temperature. The "DOOR LOCKED" light will flash when the oven door locks and unlocks or when using the Self- Clean cycle or the oven door lockout is activated. The indicator light will glow constantly after the door locks.

use.

BAKE PAD--Used to select the bake function.

STOP/CLEAR PAD--

Used to clear any function previously

entered except the time

of day and minute timer. Press STOP/CLEAR to

stop cooking. Also the

STOP/CLEAR pad is used to activate Oven

Lockout setting.

_;:,igi

*Note;The OVEN indicator light on the electronic display will turn ON and OFF when using the Bake feature and during preheat. This is normal and indicates that the oven is cycling to maintain the selected baking temperature.

When the preheat indicator !ight turns OFF, your oven is ready.

Temperature conversion

The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed for any temperature from 170°F to 550°F (77°C to 287°C).

To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):

f_
1. Press B,o_....	appears in the display.

2.Press and hold the Jk until "HI" appears in the display.

3.Press and hold B,,, until °F or °C appears in the display.

4.Press the J%. or V to change °F to °C or °C to °F.

5.Press any control pad to return to normal operating mode.

Setting Oven Controls

NOte: The time of day must firSt beset in 0rder t0 operate theoven.

To Set the Clock

When the range is first plugged in, or when the power

supply to the range has been interrupted, the display will flash "12:00".

1.Press _ once (do not hold pad down).

2.Within 5 seconds, press and hold the _ or V until

the correct time of day appears in the display.

Note: The clock cannot be changed during a Self-Clean cycle.

To Set the Minute Timer:

,Press the A to increase the time in one minute

increments. Press and hold the _ to increase the time in 10 minute increments. The timer can be set for

any amount of time from 1 minute to 11 hours and 59 minutes.

Note: If the V pad is pressed first, the timer will

advance to 11 hours and 59 minutes.

3.The display shows the timer countdown in minutes until

1 minute remains. Then the display will countdown in seconds.

4.When the set time has run out, the timer will beep 3 times and will continue to beep 3 times every 60

1. Press @.

seconds until @ is pressed.