Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appliance is supplied with the different surface gas burners:
Simmer Burner (5,000 BTU)
1 (or 2 on 36" models)
Standard Burners (9,500 BTU) 1 Power Burner (12,200 BTU or 14,200 BTU)
1 Power Burner (16,200 BTU) or Dual Burner (18,000 BTU)
Burner Cap | 36" Models only |
Burner Cap (Standard)
BurnerModels only Extra Large
"POWER" |
|
|
|
| |
Burner | Head | Left | Rear | (9,500 |
|
(12,200 | BTU or | )Gas | Opening |
|
|
14,200 | BTU) |
|
|
|
|
| Left | Front |
| Center | Burner Cap |
|
|
|
| ||
| Gas | Opening |
| Gas Opening |
|
When setting up the cooktop for the first time, make sure that the correct Burner Heads, Burner Caps and Burner Grates are located as shown in Figure 1.
|
|
| _Burner | Head |
_a | nner & Outer | (5,000 BTU) | ||
| Burner | Caps | Right | Rear |
| Gas | Opening | ||
|
|
| ||
| I Burner | Head |
|
|
| (18,000 | BTU) | Burner |
|
|
|
| ||
| Right Front | Head (16,200 BTU) |
| |
| Right Front |
| ||
|
|
|
| |
| Gas OpeningS/ | Opening |
| |
|
|
| ||
_, | Right Front | Gas | Figure 1 |
|
_, | Opening |
| Burner |
|
_. |
|
|
| |
| Dual Burner | Skirt |
| |
_ | on Models 790.3248 |
|
| |
"_790.3249 only
Burner G rate
Burner Cap
Burner Head
Electrode must be
located properly in slot of each Burner Head
Figure 2
Assembly of the Surface Burner Heads, Burner Caps, Burner Grates
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations.
1.Place all 4 (four) or 5 (five) Burner Heads in the correct locations (See Figure 1). Make sure that the correct Burner Head is placed with the corresponding Gas opening and that the Electrode is located properly in the slot of each Burner Head (See Figure 2). Proper Burner Head placement insures that each Burner will have the correct spark required for surface gas ignition.
2.Place the correct Burner Caps at each of the burner locations. Each of the Burner Heads MUST have a Burner Cap installed to insure proper ignition and gas flame size (See Figure 2).
3.Place the 2 (two) or 3 (three) cast iron Burner Grates supplied with the range. Carefully lift the burners grates on to the cooktop over the burners. Properly installed Burner Grates will rest with all Grate legs on the cooktop.
REMEMBER
7
