Setting Surface Controls
Dual Burner Head Assembly
(present on Models 790.3248 & 790.3249 only)
Make sure that the Burner Head, Burner Caps and Burner Skirt are installed properly and at the correct locations.
1.Follow the Installation Instructions before installing and using your new range.
2.Remove all packing tape from cooktop and the dual burner.
3.Discard all packing material located under all Burners (if applicable).
4.To install Burner Head, Caps & Skirt, refer to figure 1 and follow the following steps:
Step 1: Align Burner Head Pin A on Burner Base Hole.
Step 2: Place Burner Skirt around Head and Base.
Step 3: Align out Burner Outer Cap Hole into Burner Head Pin B.
Step 4: Place Inner Burner Cap centered on Burner Base.
5.Put back the grates on the cooktop.
|
|
|
| Step 4 |
Burner Outer |
|
|
| |
Cap Hole |
|
| Step 3 | |
Burner |
|
|
| / |
|
|
|
| |
Skirt |
| "., |
| / |
|
|
| ||
|
|
|
| Burner |
Burner | Headpin E_ i__ | Head | ||
|
|
|
| PinA |
Burner Head | o_ |
| Step 2 | |
|
|
|
| Burner |
|
|
|
| Base |
Burner |
|
|
| Hole |
Base |
| _. *_X._, |
| Step 1 |
|
| Figure | 1 |
|
Control Locations of the Gas Surface Burners
Your cooktop is equipped with gas surface burners with different BTU ratings. The ability to heat food quicker and in larger volumes increases as the burner size increases,
The small SIMMER burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop.
The STANDARD burners can be used for most surface cooking needs. The one or two (36" models only) burners are located at the left rear and center rear positions on 36" models.
The POWER burner is best used for bringing large quantities of liquid rapidly
Figure 2 (model 790.3248 shown only )
up to temperature or when preparing larger quantities of food. The POWER
burner is located at the right front and left front burner position on the cooktop.
Regardless of size, always select cookware that is suitable for the amount and type of food being prepared. Select a burner and flame size appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan.
Figure 3 (model 790.3249 shown only)
8
