Kenmore 790.9633, 790.9631, 790.9622 manual Adjusting the Oven Temperature, Changing the Oven Light

General Care & Cleaning

Changing the Oven Light

The oven light automatically turns ON when the door is opened. The oven light

Oven Light

Wire

Holder

may also be manually operated by pressing the @ pad.

The oven light bulb is located at the rear of the oven and is covered with a glass

shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light bulb:

		1.	Turn electrical power off at the main source			or unplug the range.
		2.	Press wire holder		to one side to release the glass shield.
		3.	Replace	bulb with	a new 40 watt appliance	bulb.
		4.	Replace	glass shield over bulb and snap wire holder into place.				back in).
9		5.	Turn power back on again at the main source				(or plug the range
	..........................	6.	The clock will then		need to be reset. To reset,		see Setting the	Clock and

Minute Timer in this Use & Care Guide.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press Bake,

2.Set the temperature to 550°F (287°C) by pressing and holding the /%.

3.Within 2 seconds, press and hold _Bakeuntil the 2 digit display appears. Release B,_k The. display now indicates the amount

of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°c),in5°Fstepsbypressingandh__dingthe/% or V. Adjust

until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press _ to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

24