Kenmore 790.9751 manual Setting Temperature Display Fahrenheit or Celsius, Setting Accent Light

Consumer Defined Control

Setting Temperature Display — Fahrenheit or Celsius

The and pads control the Fahrenheit or Celsius temperature display modes. The oven control can be programmed

to display temperatures in Fahrenheit or Celsius. The oven has been preset at the factory to display in Fahrenheit. Note: both ovens will be changed at the same time.

Instructions PRESS DISPLAY

To change display from Fahrenheit to Celsius or Celsius to Fahrenheit

1.Press and hold for 7 seconds. A beep will sound, "550" will appear "BROIL" will flash in the display (Fig. 1). After 6 seconds a beep will be heard and "F" (Fig. 2) or "C" (Fig. 3) will appear in the display.

If "F" appears, the display is set to show temperatures in Fahrenheit (Fig. 2). If "C" appears, the display is set to show temperatures in Celsius (Fig. 3).

2.Press to switch between Fahrenheit or Celsius display modes.

The display will show either "F" (Fig. 2) or "C" (Fig. 3).

3.Press to accept the change or press to reject the change.

for 7seconds

Fig. 1

Fig. 2

Fig. 3

or

Setting Accent Light

Your range includes a decorative Accent Light centered horizontally across touch-sensitive control panel. The Accent light comes with a theatre style intensity feature that slowly increases brightness at turn on and slowly fades when turning off.

When the Accent light is off, the light is in automatic mode. This means the Accent light will turn on automatically when an oven or Timer has been activated. The Accent light will turn off automatically when these functions are no longer active.

When the Accent light is OFF, it may be turned ON by pressing once. When the Accent light has been manually turned

on, it will remain on until manually turned off by pressing again. The brightness may also be adjusted.

Instructions PRESS DISPLAY

Example - To adjust the Accent light brightness:

1. Press and hold until an acceptance tone sounds (about 6

seconds)

2.	The default setting of 100 will appear in the display (See Fig. 4).	Value between	Fig. 4
3.	Using the numeric keypad, enter any digit from 0 to 100 to	0 to 100

change the brightness level. Entering 0 (Fig. 5) will effectively
turn the Accent light OFF until the brightness level is adjusted to a	Fig. 5
higher level.

4. Press to save the desired brightness setting.

Operating Oven Lights

The interior oven lights will turn ON when the oven door is opened.

Press to turn oven light ON an OFF whenever the oven door is closed.

The interior oven lights are located on the rear wall of the oven interior and are covered with a glass shield. The glass shield protects the bulb from high temperatures and should always be in place whenever the oven is in use.

To replace the interior oven lights, see Replacing oven lights in the Care and Cleaning section.

19