INSTALLATION INSTRUCTIONS
(CONTINUED)
2.CHOOSE THE VALVE LOCATION
Choose a location for the valve
that is easily accessible. It is best to connect into the side of a
vertical water pipe. When it is necessary to connect into a horizontal water pipe, make the connection to the top or side, rather than at the bottom, to avoid
drawing off any sediment from the water pipe.
3.DRILL THE HOLE FOR THE VALVE
Drill a 1/4" hole in the water
pipe (even if using a self- piercing valve) using a sharp bit. Remove any burrs resulting from drilling the hole in the pipe. Take care not to allow water to drain
into the drill. Failure to drill a 1/4 hole may result in reduced ice production or smaller cubes.
4. FASTEN THE SHUT OFF VALVE
Fasten the shutoff valve to the cold water pipe with the pipe clamp.
Pipe Clamp-
_ : | Vertical | Cold | |
Shutoff Valve |
| Water | Pipe |
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.
5.TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing washer begins to swell.
NOTE: Do not overtighten or you may crush the tubing.
Pipe Clamp _1_ | /_lntet | End |
L | Washer | |
Clamp Screwl_ |
|
|
6. ROUTE THE TUBING
Route the tubing between the cold water line and the refrigerator.
Route the tubing through a hole drilled in the wall or floor (behind the refrigerator or adjacent base cabinet) as close to the wall as possible.
NOTE: Be sure there is sufficient extra tubing (about 8 feet coiled into 3 turns of about 10 diameter) to
allow the refrigerator to move out from the wall after installation.
7. CONNECT THE TUBING TO THE VALVE
Place the compression nut and ferrule (sleeve) for copper tubing onto the end of the tubing and connect it to the shutoff valve. Make sure the tubing is fully inserted into the valve. Tighten the compression
Sad:::;_:urely J
Compression
Nut
Shutoff Va__
_11 | rule (sleeve) |
Outlet
Valve
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.
8. FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart of water has been flushed through the tubing.
26
