Manuals / Kenmore / Kitchen Appliance / Refrigerator

Kenmore 795.7130-K Tools You, May Need, How To Remove Door Handle, Removing Refrigerator Handle

Models: 795.7130-K

1 33

Page 9

		TOOLS YOU	MAY NEED
	1/4 in		_	f/_	3/32 in
	3/8 in			u
I _	10 mm	Phillips screwdriver	Flat head screwdriver	__	1/4 in 1
Hex head socket wrench		Phillips screwdriver	Flat head screwdriver	Allen wrench

NOTE: It is always recommended that the doors be removed when it is necessary to move the refrigerator through a narrow opening. If it is necessary to remove the handles follow the directions below.

NOTE: Handle appearance may vary from illustrations on this page.

HOW TO REMOVE DOOR HANDLE

1.Removing Refrigerator Handle

•Loosen the set screws with the 3/32" Allen wrench and remove the handle.

NOTE: If the handle mounting fasteners

need to be tightened or removed, use a 1/4" Allen wrench.

Mounting

Fasteners

Screw

Allen Wrench

2.Removing Freezer Drawer Handle

•Loosen the set screws located on the lower side of the handle with the 3/32" Allen wrench and remove the handle.

NOTE: If the handle mounting fasteners

need to be tightened or removed, use a 1/4" Allen wrench.

Page 9

Image 9

Kenmore 795.7130-K manual Tools You, May Need, How To Remove Door Handle, Removing Refrigerator Handle, Mounting Fasteners

Contents

REFRIGERADOR CON CONGELADOR INFERIOR BOTTOM FREEZER REFRIGERATORCONGI LATEUR INFI RIEUR RI FRIGI RATEUR Ill tSafety Instructions WarrantyParts and Features InstallationKenmore Appliance Warranty BOTTOM FREEZER REFRIGERATOR U.S.A. WARRANTYOne Year Limited Warranty Sears Roebuck and Co., Hoffman Estates, ILSears Installation Service Master Protection AgreementsSAVE THESE INSTRUCTIONS OR FREEZER BEFORE YOU THROW AWAY YOUR OLD REFRIGERATORTO CONNECT ELECTRICITY RECOMMENDED GROUNDING METHODODigital Sensor Control i Refrigerator Light INSTALLATION EWARNINGBASE GRILLE INSTALLATION When Moving Your RefrigeratorTOOLS YOU HOW TO REMOVE DOOR HANDLEMAY NEED 1.Removing Refrigerator Handlei /i HOW TO REMOVE REFRIGERATOR DOORLeft Door Right DoorLeft Door 2. Replacing Refrigerator Door Right Door1. Removing Pull out Drawer HOW TO REMOVE AND INSTALL THE PULL OUT DRAWERHOW TO REMOVE AND INSTALL THE 2. Installing Pull out DrawerPULL OUT DRAWER cont LEVELING AND DOOR ALIGNMENT LevelingDoor Alignment SETTING THE CONTROLS DOOR ALARMENSURING PROPER AIR CIRCULATION MULTI-FLOWRECOMMENDED ADJUSTMENT ADJUSTING CONTROL SETTINGSI Identify your control type FOOD STORAGE GUIDEFruit STORING FROZEN FOODLeafy vegetables FishREFRIGERATOR SHELVES REFRIGERATOR SECTIONSliding Out Shelves optional on some models To remove a sliding shelf from its metal frameCRISPER HUMIDITY CONTROL on some models PANTRY on some modelsOPTIBIN CRISPERS on some models To remove the crisper cover supportSURFACE on some models CRISPER COVER WITH LATTICE ON INNERMODULAR DOOR BINS To remove the crisperDAIRY BIN FREEZER SECTIONEGG BOX Some models DURABASE on some modelsGLIDE- OUT DRAWER BASKET on some models LIGHT BULB REPLACEMENT Electrical Shock Hazard GENERAL CLEANING TIPSExplosion Hazard OUTSIDEWHEN YOU GO ON VACATION POWER INTERRUPTIONSWHEN YOU MOVE To change the freezer lightPOWER SWITCH TO O OFF WHEN YOU SHOULD SET THE ICEMAKERICEMAKER OPERATION INSTRUCTIONSPower drill BEFORE YOU BEGINWHAT YOU WILL NEED 1.SHUT OFF THE MAIN WATER SUPPLY iNSTALLATiON iNSTRUCTiONS2.CHOOSE THE VALVE LOCATION 3.DRILL THE HOLE FOR THE VALVE10.TURN THE WATER ON AT THE SHUT OFF VALVE CONNECT THE TUBING TO THE REFRIGERATOR11.PLUG IN THE REFRIGERATOR 12.START THE ICE MAKERInstallation Section is weak or uneven or leveling legs need adjustingUNDERSTANDING SOUNDS YOU MAY HEAR REFRIGERATOR DOES NOT OPERATECOMPRESSOR MOTOR SEEMS TO RUN TOO MUCH LIGHTS DO NOT WORKThen Check ifTHE REFRIGERATOR SEEMS TO MAKE TOO MUCH NOISE FROST OR ICE CRYSTALS ON FROZEN FOODCUBES PRODUCED BY ICEMAKER ARE TOO SMALL THE DOORS ARE DIFFICULT TO OPEN