Kenmore 8519319A manual Drying tips, Damp, Cool Down, Wrinkle Guard, Heavy Duty

l} y gs d©yce ps

Select the correct cycle and dryness level or temperature for your load. If an Auto Dry Cycle is running, the display shows the

estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Manual Cycle is running, the display shows the exact number of minutes remaining in the cycle.

Cool Down tumbles the load without heat during the last few minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level.

Drying tips

•Follow care label directions when they are available.

•if you use fabric softener sheets, use only ones labeled as dryer safe. Follow package instructions.

•To reduce wrinkling, remove the load from the dryer as soon as tumbling stops. This is especially important for permanent press, knits, and synthetic fabrics.

•Avoid drying heavy work clothes together with lighter fabrics. This could cause overdrying of lighter fabrics and their increased shrinkage or wrinkling.

Cycle tips

•Dry most loads using the preset cycle settings.

•Refer to the Auto Dry or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various loads.

Drying temperature and Auto Dry Level are preset when you choose an Auto Dry Cycle.You can select a different

dryness level, depending on your load by pressing Auto Dry Level and tapping More or Less.

if you wish to adjust the cycle length of a Manual Cycle,

press More Time or Less Time. Adjust the temperature of a Manual Cycle by pressing Temperature until the desired

temperature is selected.

NOTE: You cannot choose an Auto Dry Level with Manual Cycles.

_ S

Follow the progress of your dryer with the drying Status indicator lights.

WET•

•In a Manual Cycle, if a wet item is not detected, the dryer will continue to run for the length of time selected, but the Wet light will not glow.

Damp

The Damp light glows in an Auto Dry Cycle when the laundry is approximately 80% dry. Damp Dry Signal beeps, if selected. (See "Options.")

Cool Down

The Cool Down light glows during the cool down part of the cycle. Laundry cools for ease in handling.

Clothes Dry

The Clothes Dry light glows when the drying cycle is finished. This indicator stays on during WRINKLE GUARD ®

WRINKLE GUARD °

The WRINKLE GUARD ® light glows when this option is selected. This indicator stays on with Clothes Dry.

Check Lint Screen

The Check Lint Screen light reminds you to check the lint screen. The light glows when the user selects a cycle. It goes out when the door is opened, Start is pressed, or until 5 minutes elapses.

Control Locked

The Control Locked light glows when this option is enabled.

Indicator lights

Other indicator lights show Cycle, Options, Modifiers and End of Cycle settings selected. The display shows the estimated or actual time remaining.

Select the drying cycle that matches the type of load you are drying. (See Auto Dry or Manual Preset Cycle Settings charts.)

AUTO DRY DELICATE ULTRADEUCA'_ MANUAL

MED DRY

CASUAL

CYCLES __ICYCLES

_i.o_EXPRESSDRY

DAMP•

NORMAL_/

TOUCH UP

COOLDOWN•

CLOTHESDRY•

WRINKLE GUARD •

CHECK LINT SCREEN•

CONOTOLLOCKED•

Wet

The Wet light glows at the beginning of Auto Dry or Manual cycles if a wet item is detected.

•In an Auto Dry Cycle, if a wet item is not detected after 5 minutes, the dryer goes directly into Cool Down and the Cool Down and WRINKLE GUARD <_indicators glow, if selected.

JEANS

HEAVY DUW

Auto Dry Cycles allow you to match the cycle to the load you are drying. See the following "Auto Dry Preset Cycle Settings" chart. Each cycle dries certain fabrics at the recommended temperature. A sensor detects the moisture in the load and automatically adjusts the drying time for optimal drying.

Heavy Duty

Use this cycle to get high heat for hea W fabrics such as cotton towels or bedspreads.

Jeans

Usethis cycle to get medium-high heat for drying denims.

19