CLEANING WASHER

Inside Tub

Remove items from washer as soon as cycle is completed to pre- vent development of mildew°

Often, when heavily soiled clothes have been washed, a deposit of sand or dirt may ap- pear around tub after completion of cycle,. This may be easily

removed by using a liquid

cleanser and rinsing thoroughly with water°

Cabinet

• Never use harsh, gritty or abrasive cleaners on any surface of the Electronic Laundry Center° At end of each laundry day, wipe top and both sides of washer lid and dryer door with a damp

Care and Storage

Dryer Drum

Disconnect electri-

cal supply cord before doing any of

the following cleaning or servicing

procedures on the Electronic

Laundry Center. Failure to dis- connect can cause electrical shock or

serious personal injury°

[_WARNINGJ Do not use any type of spray cleanser when cleaning dryer interior. Poisonous fumes or electrical shock can occur.

=tf drum is stained from non-

colorfast fabrics, clean with a

damp cloth and mild liquid

household cleanser° Wipe away the cleanser residue before drying the next load of clothes.

Exhaust System and interior

"CLEAN FILTER" flashing in dryer display window during opera- tion indicates blocked air flow. Stop dryer, disconnect appliance from electrical supply, and check lint filter, exhaust duct, and vent hood°

The interior of the dryer cabinet and exhaust duct can gather lint and dust over time depending on type of articles dried and amout of' use_ An excessive amount of lint build-up could result

in inefficient drying and possible fire hazard. These areas should be

cleaned approximately every 18

months by qualified service person- neL

cloth. Turn oft hot and cold

water to reduce pressure on water hoses,

Occasionally clean entire cabinet with a damp cloth. Stains on lid, top or tub can be removed with a

diluted solution of chlorine

bleach (1/2 cup to 1 quart water). Rinse well with clear water.

= Spray cans of color-matched ename! are available f_'om your SEARS Store or Service Center to

touch up scratches on painted cabinet°

CLEANING DRYER

Lint Screen

,ml

BEFORE OR AFTER

DRYING EACH LOAD

Remove and clean lint screen, located in door recess. Failure to do so will result in longer drying times.

[AWARNING] Lint screen must be in place when dryer is

operating°

Lint screen

in place

Dryer door wilI not close if tint screen is not properly inserted.

?I'lL L±

Air Grill

This should be done when grill ap- pears clogged.

AIR"_!i!

GRILL

PROCEDURE:

Remove right end of air grill first before using a small screwdriver to deflect tab to the left until it releases. Slide the right end of air grill toward rear of dryer to release locking rib along front. Slide air grill to the right to remove the left end. To reinstall air grill, position grill with locking rib towards front of dryer, insert left end into slot. Slide air grill toward front until locking rib engages front of slot. Carefully deflect right tab until it locks in place.

TO STORE LAUNDRY CENTER IN THE COLD

The unit cannot be operated in

freezing temperatures. Before stor- ing appliance, remove water from all parts of washer°

I. Turn off water supply faucets° Disconnect hoses from faucets

and drain_

2.Add 1 gallon of non-toxic RV antifreeze (available from hard-

ware or recreational vehicle store) to washer tub.

3.Touch SPIN ONLY.

4.Let washer spin for 1 or 2 minutes to let all water drain out. Some but not all of the RV anti- freeze will be expelled.

5.Dry tub interior, disconnect elec- trical plug and close lid,

Store appliance in an upright posi- tion.

To remove antifreeze after storage, run washer through a complete cycle using 112 cup detergent. Do not add clothes load.

PAGE 14

Page 14
Image 14
Kenmore 91801191901, 91851/91951 warranty Cabinet, Air Grill, Cleaning Washer, Lint Screen