Kenmore C675-25010 manual Models with Frostguard De-icerControl, Dont’S To Remember

Models with Frostguard™ De-icer Control

The Frostguard™ de-icer senses ice build up on the evaporator coil and automatically shuts off the compressor. The fan continues to run, drawing air across the coil and melting the ice. When the coil is defrosted, the Frostguard™ de-icer sensor restarts the compressor auto- matically. Refer to the performance chart, on the water pan operating temperatures at various relative humidity levels.

Models without Frostguard™ De-icer Control

If icing should occur, unplug unit until ice melts and room temperature is above 18°C (65°F).

"DONT’S" TO REMEMBER

1.Don't alter or change the plug on the power supply cord of your dehumidifier. Changes would make it unsafe, could cause serious damage to the dehumidifier, and might void this warranty.

2.Don't plug in the dehumidifier if you are in doubt about the grounding of your electrical system. Consult a qualified electrician first.

3.Don't use a lamp cord. If necessary use an approved grounded appliance extension cord with a maximum length of 6 ft. and minimum wire thickness of 14 guage.

4.Don't use a circuit that will become overloaded when the dehumidifier is added.

5.Do not sit or stand on the dehumidifier.

KNOW YOUR KENMORE DEHUMIDIFIER

FILTER - BACK GRILLE

EVAPORATOR COIL (LOCATED BEHIND GRILLE)

HUMIDISTAT

DIRECT TO DRAIN FITTING

FAN SPEED

CONTROL

FLOAT

MOISTURE PAN

MODEL/SERIAL NO. PLATE

BEHIND PAN

THIS OWNER'S MANUAL COVERS ALL KENMORE DEHUMIDIFIER MODELS.

Your model number can be found on a decal located in the rear of the unit behind the moisture pan.

3