Kensington K39561 quick start LED Behavior and Explanation, Charge the Battery

3Find the best fit for your Keyboard and iPad

4Press the On/Off Switch for 1.5 to 5 seconds. The Power Indicator Light glows.

NOTE: When you first turn on the Keyboard, both the Power Indicator Light and the Bluetooth Status Indicator Light glow for 5 seconds. You cannot connect the Keyboard to your iPad until only the Power Indicator Light glows.

5On your iPad, tap Settings.

6Open Bluetooth and make sure Bluetooth is on.

7On the Keyboard, press the Bluetooth Connection Button. The Bluetooth Status Indicator Light starts blinking for 10 minutes or until connected to a device.

8The Keyboard now appears on your iPad screen. Tap Bluetooth Wireless Keyboard.

9Your iPad screen displays a passkey. Enter the passkey on the Keyboard, and press Enter.

10Your iPad screen shows the Keyboard as Connected. On the Keyboard, the Bluetooth Status Indicator Light turns off.

11You can now use your Keyboard to type in any app.

NOTE: To insure the K Lock key works correctly please ensure you do the following:

4

Home page > Settings > General > Passcode key. Verify “Require Passcode” is set to “Immediately” otherwise a keyboard unlock will not require a passcode. Go back to previous menu and verify “Passcode Lock” is On.

Note the following about the Bluetooth connection between the keyboard and your iPad:

•Keyboard will go into pairing mode if the On/Off Switch is pressed for 5 seconds or longer then released (regardless of on or off state).

•Press the On/Off Switch for 1.5 to 5 seconds then release = toggle keyboard power (on to off, off to on).

•First turn (Factory default, no prior paired BT devices) – enter pairing mode automatically.

•In ON state only - Hold “CTRL + FN + F” for 3 seconds or more = reset to factory default mode (clear all previously paired BT devices in memory), ALL LEDs should flash on and off 3 times and keyboard should turn to off mode.

•If there is no active key press for 1 minute, the keyboard should go into sleep mode.

•Anytime a key is pressed in sleep mode, the keyboard should automatically connect to last paired iPad if present. If iPad is not found after waking from sleep mode within 30 seconds, the device should go back to sleep.

LED Behavior and Explanation

LED Behavior	Explanation
	• If the Keyfolio is off, asleep, or the battery is dead, the LEDs will remain
	off.
	• Initially at power-up, the Power and Bluetooth LEDs will turn on and stay
	lit for 5 seconds.
	• After 5 seconds the Bluetooth LED will turn off, followed by the Power
	LED 0.5 second later.
	• When the Bluetooth Connection Button is pressed, the Power LED will
	stay solidly lit, while the Bluetooth LED will begin to blink for 10 minutes
	or until connected to an iPad.
	• Blink pattern: ON 1s, OFF 0.5s
	• Once the Keyfolio is connected with your iPad, the Power LED will remain
	lit and all others will go off.
	• Also, if the Keyfolio is awoken from sleep mode, the Power LED will turn
	on immediately.
	• While the Keyfolio is connected to your iPad, the state of the Caps Lock
	toggle is shown by the Caps Lock LED.
	• When the Keyfolio is plugged into a power source, the Charge LED will
	turn red and turn off only when charge is completed.

Charge the Battery

Charge your KeyFolio Expert before initial use or when the Charging Indicatorblinks green.

1Insert the small end of the Charging Cable into the micro USB Charging Connector on the Keyboard.

5