KENWOOD CHEF AND MAJOR KM030 Ð KM040 series
troubleshooting
problem
●The whisk or
solution ● Adjust the height. HereÕs how:
1Unplug.
2Raise the mixer head and insert the whisk or beater.
3 Hold it, then loosen the nut
4 Lower the mixer head.
5 Adjust the height by turning the shaft. Ideally the
6 Raise the head, hold the
problem
●The mixer stops during operation.
solution ● Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and press the start/stop button. If the mixer does not restart immediately allow to stand for additional time.
●If for any reason power to the mixer is interrupted and the machine stops working, switch off by pressing the start/stop button, wait a few seconds and then switch on again. The mixer should resume operating straight away.
to fit and use your splashguard
1Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside of the mixer head until fully located. The hinged section should be positioned as shown.
4Insert required tool.
5Lower the mixer head.
●During mixing, ingredients can be added directly to the bowl via the
hinged section of the splashguard .
●You do not need to remove the splashguard to change tools.
CHEF
1
MIN
P
3 | 4 |
2
1
N
MI
P
5