Disc source

?The disc control mode cannot be selected.

✔ No wire has been connected to the disc

changer input terminal on the unit. Connect the wire to the disc changer input terminal on the unit.

?The specified disc does not play, but another one plays instead.

✔ The specified CD is quite dirty.

Clean the CD.

✔The CD is upside-down.

Load the CD with the labeled side up.

✔The disc is loaded in a different slot from that specified.

Eject the disc magazine and check the number for the specified disc.

✔The disc is severely scratched. Try another disc instead.

?The sound skips.

✔Something is touching the disc changer. Remove whatever is touching it.

✔The CD is scratched or dirty.

If skipping happens at the same place when the car is stopped, something with the CD is wrong. Clean the CD.

?The display shows that the changer is being played, but no sound can be heard.

✔The computer chip in the unit is not functioning normally.

Press the reset button on the unit (page 4).

?The specified track will not play.

✔Random play or magazine random play has been selected.

Turn off random play or magazine random play.

?Track repeat, disc repeat, track scan, disc scan, random play, and magazine random play start by themselves.

✔ The setting is not cancelled.

The settings for these functions remain on until

the setting to off or the disc ejected, even if the power is turned off or the source changed.

Troubleshooting Guide

?Can not remove disc.

✔The cause is that more than 10 minutes has elapsed since the vehicle ACC switch was turned OFF.

The disc can only be removed within 10 minutes of the ACC switch being turned OFF. If more than 10 minutes has elapsed, turn the ACC switch ON again and press the Eject button.

MP3/WMA source

?Cannot play an MP3/WMA.

✔ The media is scratched or dirty.

Clean the media, referring to the Disc cleaning

of the section on <About discs> (page 13).

?The sound skips when an MP3/WMA is being played.

✔ The media is scratched or dirty.

Clean the media, referring to the Disc cleaning

of the section on <About discs> (page 13).

✔The recording condition is bad.

Record the media again or use another media.

?The MP3/WMA track time is not displayed correctly.

✔ ---

There are times when it isn’t displayed correctly according to the MP3/WMA recording conditions.

?Can not display the ID3 tag information correctly.

✔Record is not made in conformity with the ID3 tag version 1.x.

Record in conformity with the ID3 tag version 1.x.

Also, the display may be incorrect if an MP3/WMA file uses the ID3 tag v1.x standard and if this standard has been expanded after production of the machine software.

English 85