Timer operations
Timer playback of CD can be started at any time using an audio timer which is available in audio stores.
Preparation | ÷Connect the power cords of the associated |
| components so that their power can be turned |
| ON through the audio timer. |
| (Also, be sure to read carefully the instruction |
| manual of the timer.) |
This unit
0 | 7 | 6 |
| 4 | ¢ |
| 1 | ¡ |
System control cord | Audio cord | 21 |
Amplifier
2Preparation
| Load a disc in the CD player. | @ |
| Label side |
0 |
|
7 | 6 |
|
12 F00
Audio timer | To wall AC outlet |
÷If the amplifier is not connected to the CD player through a system control cord, select the “CD” input with the input selector.
3Set the amplifier volume.
1Play the disc.6
| 2 Adjust the amplifier volume. |
| Adjusting the volume: | |
| (Use the remote control unit of this unit | Note | Set the volume the maximum (0 dB) using the OUTPUT |
| to adjust the volume to the maximum | ||
|
| (UP) key on the remote control unit, and adjust the vol- | |
| level.) |
| |
|
| ume to the desired level on the amplifier side. | |
|
|
| |
| 3 Stop the disc. |
| (Since the sound output is at the maximum level when the | |
|
|
| power is turned on, lowering the level with the remote control |
|
|
| will change the volume.) |
|
|
| |
7
4Set the timer ON time.
Set the timer so that it supplies power at the specified time.÷With some audio timer models, the power is automatically turned OFF when the timer ON time is set. With such a model, skip step 5 below.
5Turn OFF the power output from the audio timer.
÷Do not touch the ON/STANDBY or POWER switches of the amplifier and CD player.
÷When the set time comes, the disc playback starts automatically.
| 1. | Some amplifiers cannot be used with a timer. Before using a amplifier, check it. |
Notes | 2. | When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player. |
|
|