— 12 —
English
Tuner features
Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
Turn the power off.
Hold down buttons #1 and #5, then turn the power back on.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Repeat steps 1 and 2 above.
NOTE
2
1

Frequency Step Setting

You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as
follows:

Switching Display for Tuner

Character
Station frequency
SNPS name (only when being preset)
Clock
Spectrum analyzer
You can assign names to radio stations with the Station Preset
Memory. Up to 30 stations can be assigned names.
Adjust the frequency to the station whose name you want to
enter.
This function cannot be available during the clock display.
Press the NAME.S button for at least two seconds.
"Name Set" is displayed once the station name preset mode is
entered.
The cursor will blink in the position where letters are entered.
Press either the 4or ¢button to move the cursor to the
desired position.
The 4button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the 4
or ¢buttons, respectively, on the remote.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
4
3
2
NOTE
1

Station Name Preset (SNPS)

Temporarily have reception switched from stereo to mono to
reduce multi-path noise when listening to the FM station.
The factory default for this function is ON.
Turning CRSC On/Off:
Press the CRSC button for at least one second to turn the
function on/off. "CRSC On" is displayed when CRSC is on.
The mc indicator lights up when CRSC is off.
Strong electrical fields (such as from power lines) may cause
unstable sound quality when CRSC is turned on. In such a
situation, turn it off.
NOTE

Clean Reception System Circuit (CRSC)

DPX-5050_M_r1_U.S 03.1.21 0:01 PM Page 12