Temporarily have reception switched from stereo to mono to
reduce multi-path noise when listening to the FM station.
The indicator lights up when CRSC is off.
Turning CRSC On/Off:
Press the CRSC button for at least one second to turn the
function on/off.
Strong electrical fields (such as from power lines) may cause
unstable sound quality when CRSC is turned on. In such a
situation, turn it off.
NOTE
Clean Reception System Circuit (CRSC)
Tuner features
— 10 —
English
You can recall a station being preset in preset station buttons
(#1-6).
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
Preset Tuning
You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as
follows:
Station frequency
"SNPS"
"Clock"
"Character"
Switching Display for Tuner
When you know the frequency of the station that you want to
listen to, you can input it directly for quick access.
Select the band by pressing the FM or AM button.
Press the DIRECT button.
"----" is displayed for 10 seconds.
If you make no input in the 10-second period, direct access
tuning is automatically cancelled.
Enter the frequency of the desired station.
If you want to listen to an FM station at 92.1 MHz, for example,
press 9, 2, and 1.
If you want to listen to an AM station at 810 kHz, for example,
press 8, 1, and 0.
•You cannot enter frequencies above or below what a band can
receive.
•FM frequencies can only be input in 0.1 MHz steps, and not
0.01MHz steps.
Cancelling Direct Access Tuning:
Press the DIRECT button again.
NOTE
3
2
1
Direct Access Tuning (Function of remote control)
Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
Turn the power off.
While pressing the button #1, press the button #5. Hold down
both of these buttons, then press the SRC button.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
When you change the frequency step settings, part of memory
contents (except for SNPS) will be erased.
Returning Frequency Step Settings to Original Values:
Repeat steps 1 and 2 above.
NOTE
2
1
Frequency Step Setting